Burley 9514 Installationsanleitung & Benutzerhandbuch - Seite 11

Blättern Sie online oder laden Sie pdf Installationsanleitung & Benutzerhandbuch für Holzofen Burley 9514 herunter. Burley 9514 20 Seiten.

Chimneys

The 9507 requires a chimney of minimum 5" (125mm), model 9510 requires a chimney of

minimum 6" diameter (150mm), model 9514 requires a chimney of minimum 7" (175mm)

diameter. All chimneys must be a minimum length of 4 metres above the stove and they

must comply with Building Regulations J. Never share the flue with another appliance.

The distance from the edge of the stove to the centre of the flue pipe is 105mm.

Without a chimney to these specifications there could be insufficient draw on the

chimney to pull sufficient oxygen through the appliance to make it burn properly.

If you live in a valley or are surrounded by tall trees or buildings you might experience

downdraught problems where the wind tries to stop the fumes rising up the chimney. An

anti-downdraught cowl might help, but anti-downdraught cowls reduce draw, so will not

work on single storey chimneys and those with insufficient draw.

We recommend you seek the advice of a HETAS (0845 634 5626) or NACE (01526 322

555) registered supplier and installer before purchasing any stove or heating appliance.

To prevent possible damage in transit the control levers and their components are

shipped inside the stove.

Having positioned your Burley stove & connected it to a chimney with flue pipe, (we recommend

1mm stainless steel pipe sprayed matt black – do not use vitreous enamel unless it is known to

be coated stainless steel) you need to assemble the inside parts. There are 5 internal

components: top baffles, 2 side cheeks and a rear brick.

Place the top baffle loosely in position resting on the back square steel columns.

Place the left hand side brick in place, followed by the right hand. The top baffle can then be

placed correctly and the rear brick inserted.

Finally, when these parts are snugly in position with the top baffle as far to the back as it will go,

When sweeping the chimney or carrying out regular maintenance on the stove, reverse the

above procedure, clean the chimney and the top surface of the top baffle then reposition all the

components.

Page 11 of 20