Burley Launde 9304-C Installationsanleitung & Benutzerhandbuch - Seite 16

Blättern Sie online oder laden Sie pdf Installationsanleitung & Benutzerhandbuch für Holzofen Burley Launde 9304-C herunter. Burley Launde 9304-C 20 Seiten. Fireball with catalytic converters

Seite drucken

Leaving the lever to the right will cause a roaring fire, this may look impressive but you are burning

a lot of fuel and creating much less warmth for the house. Over firing damages internal

components and catalytic converter (s) and invalidates your warranty.

The best way to refuel any wood stove is 'little and often' and Burley's stoves are no different. it is

best to keep adding a small log every 45 minutes rather than adding large ones every 2 hours.

It may be tempting to load up the stove and shut it down in the hope it will still be alight in the

morning but this is unwise. A slumbering stove does not burn, it smoulders, and rather than the

creosote bring burned, it will deposit tar on the inside of the stove and the flue, excessive deposits

are a major cause of chimney fires.

THE STOVE IS NOT DESIGNED TO BE USED WITH THE DOOR OPEN!

To reload, open the door slowly to allow the pressure to equalise. Using the glove provided, place

the fresh log towards the rear of the appliance. Close the door.

Do not over load any stove with fuel and close the damper down, this produces lots of

creosote and blackens the glass

Recommended fuels & using the Moisture Meter

9104, 9304 & 9404

9105, 9305 & 9405

9307

9108, 9308 & 9408

Model

Dry logs <20% H₂O

Dry logs<20% H₂O

Maximum length 200 -

Maximum length 250 -

Maximum length 250 -350mm

250mm long

300mm long

lonG

Maximum width 150mm

For the stove to operate at maximum efficiency the wood should be as dry as possible, certainly

below 18%. Burning damp or wet wood will not only stop the stove working efficiently, but also

create excess smoke and stain the glass.

Remove the plastic cap covering the two contact pins. The pins

are sharp for a reason, so please use it carefully. Push the pins

into the inner surface of the split log (5mm as a guide) this will

give an accurate reading.

Simply putting the contact pins onto the surface will not give an

accurate reading, as it may tell you that the surface is dry

whilst the interior of the log may well be damp.

Stove Thermometers - DO NOT USE WITH OUR STOVES

We receive a very small number of calls from customers who have managed to damage their

stoves from over-firing, in almost all cases they have a thermometer fitted to their flue.

These stoves are the world's most efficient because firstly, due to the unique method of

introducing air, the combustion chamber is extremely hot, and secondly, the heat is extracted from

the combusted gasses to heat the room before it enters the flue, so the chimney is cooler than

with normal stoves.

Because the thermometer is not 'in the green', you think that the stove is not operating efficiently,

so load the chamber with wood and have the air wide open. This creates such an inferno that

Page 16 of 20