Diamond TQ-800 Installations- und Betriebshandbuch - Seite 4
Blättern Sie online oder laden Sie pdf Installations- und Betriebshandbuch für Kommerzielle Lebensmittelausrüstung Diamond TQ-800 herunter. Diamond TQ-800 20 Seiten. Electric conveyor toasters
Seite druckenIMPORTANT! Read the following important safety instructions to avoid personal injury or
death, and to avoid damage to the equipment or property.
WARNINGS
Plug toaster into a properly grounded
electrical outlet of the correct voltage, size,
and plug configuration. If the plug and
receptacle do not match, contact a qualified
electrician to determine the proper voltage
and size, and install the proper electrical
outlet.
To avoid any injury, turn the power switch
OFF, unplug the unit from the power source
and allow to cool before performing any
maintenance.
For safe and proper operation, the unit must
be located at a reasonable distance from
combustible walls and materials. If safe
distances are not maintained, discoloration
or combustion could occur. Do not locate
toaster under shelving or closer than 12"
(305 mm) from the ceiling.
To assure safe and proper operation while
operating in the Front Discharge mode, allow
a minimum clearance of 1" (25 mm) along the
sides and rear. Allow a minimum clearance of
12" (305 mm) along the front.
To assure safe and proper operation while
operating in the Rear Discharge mode, allow
a minimum clearance of 1" (25 mm) along the
sides. Allow a minimum clearance of
12" (305 mm) along the front and rear.
To prevent any injury or damage do not pull
unit by power cord.
To prevent any injury, discontinue use if
power cord is frayed or worn.
If the Warning light on the control panel is lit,
appliance is malfunctioning. Turn OFF the
power to the unit and allow to cool. Once
cool, disconnect appliance from power
supply and have unit serviced by a qualified
technician.
If service is required on this unit, contact
your Authorized Hatco Service Agent, or
contact the Hatco Service Department at
800-558-0607 or 414-671-6350; fax 800-690-
2966 or International fax 414-671-3976.
IMPORTANT SAFETY INFORMATION
This product has no "user" serviceable parts.
To avoid damage to the unit or injury to
personnel, use only Authorized Hatco Service
Agents and Genuine Hatco Parts when
service is required.
Genuine Hatco Replacement Parts are
specified
environments in which they are used. Some
aftermarket or generic replacement parts do
not have the characteristics that will allow
them to operate safely in Hatco equipment. It
is essential to use Hatco Replacement Parts
when repairing Hatco equipment. Failure to
use Hatco Replacement Parts may subject
operators of the equipment to hazardous
electrical voltage, resulting in electrical
shock or burn.
To avoid any injury or damage locate the unit
at the proper counter height, in an area that is
convenient for use. The location should be
level to prevent the unit or its contents from
accidentally falling, and strong enough to
support the weight of the unit and food.
Do not place anything on top of the toaster;
doing so could damage toaster or subject
personnel to possible injury.
The toasting of coated or buttered products
such as garlic bread, cheese sandwiches and
sweet rolls is NOT recommended. Residue
will reduce toaster performance and could
possibly ignite inside the toaster.
When setting up the unit for operation, make
sure power to the unit is off and the toaster is
at room temperature. Failure to do so could
result in personal injury.
Some exterior surfaces on the unit will get
hot. Use caution when touching these areas
to avoid injury.
To avoid damage to the unit or injury to
personnel always operate toaster with crumb
tray installed.
To avoid any injury, do not remove the crumb
tray for cleaning until toaster is cool.
1
to
operate
safely
CAUTIONS
Form No. TQ2M-1005
in
the