Diamond VK38-120 Installationshandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Installationshandbuch für Kommerzielle Lebensmittelausrüstung Diamond VK38-120 herunter. Diamond VK38-120 13 Seiten.

Seite drucken

Important safety instructions

1. To obtain full use of the cabinet, we recommend reading this instruction manual.

2. It is the user's responsibility to operate the appliance in accordance with the instructions

given.

3. Contact your dealer immediately in case of any malfunctions.

4. Place the cabinet in a dry and ventilated place.

5. Keep the cabinet away from strongly heat-emitting sources and do not expose it to direct

sunlight.

6. Always keep in mind that all electrical devices are sources of potential danger.

7. Do not store inflammable material such as thinner, gasoline etc. in the cabinet.

8. We declare that no asbestos nor any CFC are used in the construction.

9. The oil in the compressor does not contain PCB.

Unpacking and installation

Remove the wooden pallet and the packing. External surfaces are supplied with a protection foil,

which must be removed before installation

Electrical connecting

The cabinet operates on 230 V/50 Hz.

The wall socket should be easily accessible.

All earthing requirements stipulated by the local electricity authorities must be observed. The

cabinet plug and wall socket should then give correct earthing. If in doubt, contact your local

supplier or authorized electrician.

The flexible cord fitted to this appliance has three cores for use with a 3-pin 13-Amp or 3-pin 15-

Amp plug. If a B.S. 1363 (13-Amp) fused plug is used, it should be fitted with a 13-Amp fuse.

The wires in this mains lead are coloured in accordance with the following code:

Green/Yellow: Earth, Blue: Neutral, Brown: Live.

The main electrical connections must be done by skilled electricians.

Start-up of the cabinet

Before use, we recommend that the cabinet is cleaned, see the section on maintenance and cleaning.

Important !

If the cabinet has been vertically placed during transport, please wait 2 hours before starting up the

cabinet.

Connect the cabinet to a socket and turn on the switch on the control panel, see fig. 1.9.