AQUASCAN INTERNATIONAL CSE Series Handbuch - Seite 13

Blättern Sie online oder laden Sie pdf Handbuch für Fischfinder AQUASCAN INTERNATIONAL CSE Series herunter. AQUASCAN INTERNATIONAL CSE Series 20 Seiten.

Seite drucken

AquaScan General directions

version: 1.6 Model: CSE-series

Electrical connection/disconnection

Avoid water at the contact pins of the connectors whenever the Registration Units are connected to the

Control Unit, and when powering the system. Connect the Registration Units to the Control Unit

before you apply the correct grounded power source. If the power is coming from a generator etc. it is

important that AquaScan is not connected to power during start-up or shut-down of such equipment.

Ensure that the power source is stable.

The Control Unit will do a self-test during power-up.

Make sure that the connectors are tightened properly. If you are using an extension cord between the

Registration Unit and the Control Unit, make sure that the connectors are never put directly under

water. The power source must be turned off before disconnecting the Registration Units. Always

mount the sealing cap on both the male and female connectors when not in use, to avoid access of dirt

and water.

Connection of transportation-pipe to Reg. Unit:

The Registration Unit should be installed in such a way that the long sides are vertically. At inlet

(marked IN) connect a straight pipe with a length of minimum 1 meter and same diameter as the

Registration Unit. This pipe can then e.g. be connected to another pipe with another diameter. The

reason for the angel between the de-waterier and the straight pipe is to spread and accelerate the fish,

before the fish passes through the counter.

The pipes need to be completely opaque to avoid direct sunlight reaching into the unit. The area of

registration (light sheet and lens) in the Registration Unit must be protected against light from the

outside world.

Try to minimize the amount of water flowing through the unit. Too much water can disturb the

sensor's measurement. A dewatering system will be necessary especially if the level of water can

reach over 1/4 of the pipe. Avoid water to foam/whirl through the counter. Make sure the counter

does not «count» water and do not add water until the whole fish has passed through.

Page 13 of 20