AquaScape 39000 Einbauanleitung

Blättern Sie online oder laden Sie pdf Einbauanleitung für Außen-Brunnen AquaScape 39000 herunter. AquaScape 39000 2 Seiten.

Seite drucken

I N S T A L L A T I O N

300-WATT POND

DE-ICER

300-Watt Pond De-Icer

Item #39000

Safety Information

WARNING: We recommend that you store your Aquascape 300-

Watt Pond De-Icer indoors, when not in use or after the winter

season. Inspect cord before using. Do not use extension cords.

Read all instructions carefully, before installation. Take extreme caution

when working on or near a frozen pond. Never walk on thin ice.

WARNING: To provide continued protection against risk of electric

shock, connect to properly grounded outlets only, using the

following guidelines:

(A)

Have a qualified electrician install a properly grounded receptacle

outlet, acceptable for outdoor use and protected from snow and

rain, immediately adjacent to the location where the 300-Watt Pond

De-Icer will be used.

(B)

Route supply cord and locate the heater so as to be protected from

damage by live stock.

(C)

Do not use extension cords.

(D)

Inspect cord before use.

(E)

Unplug 300-Watt Pond De-Icer at receptacle outlet when not in use

or before removal from pond.

(F)

Store 300-Watt Pond De-Icer indoors after winter season, or when

not in use.

Installation

• We recommend floating the 300-Watt Pond De-Icer over the deepest

part of the pond. If the ice is completely frozen, laying the heater on its

side will enable it to melt through the ice slowly (Ex. 1). You may have

to adjust or reorient the heater in an upright position as it starts to melt

through the ice. Be patient, heater may take several hours to completely

melt through. Never break the ice with force; the shock will stress

fish and could cause unnecessary fish loss. We recommend floating

the heater in the pond for about one hour before plugging in the unit,

allowing the unit to calibrate to the water temperature.

facebook.com/aquascapeinc

youtube.com/aquascape4

pinterest.com/aquascapeinc

instagram.com/aquascape_inc/

Ex. 1

I N S T R U C T I O N S

• Plug the electrical cord into a

GFCI-regulated power receptacle

(Ex. 2). The indicator light will

be red when the unit is warm or

heating and blue when it is cool or

not heating.

WARNING: When indicator light is red the unit will be very hot.

Do not touch unit when indicator light is red. Make sure unit is

unplugged and given time to cool, before touching.

• In the springtime, or when heater

is no longer needed, unplug the

unit and let sit in the pond for at

least one hour, to allow for proper

cooling (Ex. 3).

• Prior to storing the unit, when not in

use, we recommend that you clean

the outside surface with a mild acid,

like white vinegar, and then rinse

thoroughly with clean tap water.

This will remove calcium deposits

and will not damage the stainless

steel finish. Allowing calcium deposits to build up on the unit may impede

the thermostat from working correctly.

Troubleshooting

• In the event that the 300-Watt Pond De-Icer should malfunction or fail to

operate, please check the following:

– Check to ensure that the unit is plugged in properly.

– Make sure that the GFCI-rated receptacle or ground fault interrupter is

operating properly.

– Check to see that the LED light on the top of the unit is indicating

that the unit is heating. LED light will be red when unit is heating. If

the indicator LED light on top of the unit is blue, the heater is in the

off mode and not heating. The LED indicator light and thermostat

is a safety function of the heater to prevent accidental burns. If

not functioning correctly you may need to reset the thermostat by

unplugging the heater for approximately one hour, to allow the heater

to completely cool. When you plug in the heater the LED indicator

should turn red, indicating heating.

NOTE: The thermostat on the heater is set to turn off at 70F or 21C, the

thermostat or safety shut-off is a safety feature and not meant to turn off

the heater when ice is not present.

Warranty Information

3 YEAR WARRANTY

Aquascape warrants that the 300-Watt Pond De-Icer will be free of

manufacturing defects for three years from date of purchase. Proof of

purchase required. Warranty does not cover damage resulting from

electrical supply problems, lightning, negligent handling, misuse or lack of

reasonable maintenance or care. This product should only be operated in

fresh water without corrosive chemicals like chlorine or bromine. If upon

Aquascape's inspection, the de-icer shows evidence of a manufacturing

defect, Aquascape's liability is limited, at Aquascape's option, to the repair

of the defect, replacement of the defective product or refund of the original

purchase price. The warranty excludes costs of labor, removal of product,

shipping and expenses related to the installation and re-installation of the

product. No liability for loss or damage of any nature or kind, whether

arising out of or from the use of the product, whether defective or not

defective, is assumed by Aquascape, Inc. or its affiliates. Aquascape shall

not be liable for any incidental, consequential or other damages arising

under any theory of law whatsoever.

For more information about our company or products, please visit our website at

aquascapeinc.com or call us at US (866) 877-6637 CAN (866) 766-3426

Ex. 2

Ex. 3

01/22