Panasonic AG-DVC 200E Betriebsanleitung - Seite 11
Blättern Sie online oder laden Sie pdf Betriebsanleitung für Camcorder Panasonic AG-DVC 200E herunter. Panasonic AG-DVC 200E 44 Seiten. Digital video camera recorder
Preparation
Using the AU-BP402 or AJ-BP490 battery pack made by Panasonic
Recharge the battery pack using the battery charger specifically designed for each individual battery pack. For the charging time and other
details, refer to the operating instructions of the battery charger used.
1
Remove the battery holder.
Disconnect these.
Disconnect these.
2
Attach the battery case to the unit.
1Connect the unit's cable with the cable of the AU-M402H
battery case.
2Use a screwdriver to attach the AU-M402H battery case to
the unit.
The holes for tightening the screws can be seen when the
cover is opened and the rubber caps are raised. Use a
screwdriver to tighten the screws, and attach the battery
case to the unit. Ensure that the screws are tightened up as
far as they will go.
<Note>
≥Do not pull the rubber caps with great force.
≥Be careful not to catch up the cables when attaching the
battery case.
Screws
Connect here.
Battery holder
Rubber caps
AU-M402H
battery case
10 (E)
3
Connect the plug of the battery pack to the
connector inside the battery case, and
insert the battery pack into the case.
Label
surface
<Note>
Ensure that the power is turned off before connecting or
disconnecting the plugs.
4
Set the battery type.
Select the battery type using <BATTERY> on the sub-menu
screen.
Select "TYPE A" if the AJ-BP490 is to be used; select "NiCd12"
if the AU-BP402 is to be used. (See page 34)
AU-BP402
battery pack