Panasonic AG-DVC200E Betriebsanleitung - Seite 28

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Camcorder Panasonic AG-DVC200E herunter. Panasonic AG-DVC200E 44 Seiten. Digital video camera recorder

Seite drucken

Audio recording

Selecting the audio input signals

Select the desired input signals using the

AUDIO IN switch.

To use the front microphone i Select FRONT (MIC).

To use the rear microphone i Select REAR (MIC).

To use the audio products

<Notes>

≥When the front microphone has been selected, select ON as the

<FRONT MIC POWER> setting for the MIC/AUDIO sub-menu

item if the phantom mic (+48 V) needs to be supported. (See

page 35)

≥When the exterior microphone is selected and phantom mic

(+48 V) needs to be supported, set the mic power switch to ON.

Adjusting the audio recording level

When the AUTO SELECT CH1/CH2 selector switch is set to AUTO,

the input levels of the CH1 and CH2 sound are automatically

adjusted.

To adjust the input levels of the CH1 and CH2 sound manually,

proceed as follows:

Set the AUTO SELECT CH1/CH2 selector

switch to MAN.

While monitoring the audio level meter

inside the viewfinder, adjust the AUDIO

LEVEL CH1 and CH2 controls in such a

way that the maximum input level does not

exceed "- - - - - + - - +."

<Note>

If the audio input level drops to the extent that there is no input,

some noise will be recorded at the start point of the recording. Set

the AUDIO LEVEL CH1 and CH2 controls to ensure that this does

not occur.

Monitoring the sound during

recording

The audio input signals can be monitored through the monitor

speaker or earphone. When the PHONES jack is used, no sound

will be heard through the monitor speaker.

The volume of the monitored sound can be adjusted using the

MONITOR control.

<Note>

Howl may be caused if the volume of the audio monitor speaker is

too high. In this situation, rotate the audio monitor level control to a

lower level which does not give rise to howl.

i Select REAR (LINE).

Monitor

speaker

JOG dial button

MONITOR control

TAPE NEAR END FLUO.

iREC

TCG 12:34:56:00

¢1¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢

¢2¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢

SPOT

160

LOW LIGHT

=========

C H 1

48K

C H 2

CH1

CH2

–32 –28 –24 –20 –16 –12 –8

27 (E)

AUDIO LEVEL

CH1 control

CH2 control

Mic power switch

AWB+02

QUICK FOCUS

D01-M a y -01 23:59:00

¢¢¢ min 1 3 . 4V

The reference value

AUDIO

SELECT

switch

AUDIO IN

switch

PHONES

jack

Z78

32K

ATW

F56

0d B

FL1

–4

0dB