Diamond CB425A Anleitung für Installation, Gebrauch und Wartung - Seite 12

Blättern Sie online oder laden Sie pdf Anleitung für Installation, Gebrauch und Wartung für Eiswürfelbereiter Diamond CB425A herunter. Diamond CB425A 15 Seiten. Automatic ice - cube maker

Seite drucken

For appliances that are connected permanently to

the electricity main, turn on by means of the switch

on the outside of the appliance, fitted during the

installation phase.

Start by pressing the relative switch (21 Fig. 9) which

will light up if provided with this function.

6.3

STARTING

CONTINUOUS DELIVERY (Fig. 10)

Carry out operations a) and b) described above;

then:

•

remove the plug (22) on the front grille panel;

•

using a screwdriver (23) turn the adjuster screws

of the timer clockwise until you hear a click and

the water pump stops;

•

repeat the previous operation three times

consecutively at intervals of one minute each;

•

when this operation has terminated, fit the plug

(22) back on the front grille; the appliance will

automatically start producing ice.

7 MAIN CAUSES OF OPERATING FAILURE

Should the appliance fail to produce ice, before

calling on the Authorized Technical Service Center,

first check carefully that:

•

the water supply tap (10, Fig. 4), fitted during

the installation phase, has been turned on.

•

electric power is reaching the appliance; the plug

is properly inserted, the corresponding switch

(9 Fig. 4) is in the "ON" position, and the push

button (21 Fig. 9) is lighted up.

Furthermore:

•

if there is excessive noise, make sure that the

appliance is not touching furniture or sheet metal

which can give rise to noise or vibrations;

•

should any trace of water appear, check the

drain hole of the container to ensure that it is

not clogged, that the water fill and drain pipes

are correctly connected and are not throttled or

damaged.

•

make sure that the temperature of the air or

water does not exceed the installation limit

values.

•

make sure that the water inlet filter is not

clogged.

MODELS

WITH

•

make sure that the spray nozzles are not

clogged with scaly deposits.

If the fault still persists after the above inspections

have been made, turn off the electric power source

by means of the switch fitted during the installation

phase, pull out the plug from its socket, turn off the

tap connecting the appliance to the water main, and

contact the nearest Authorized Technical Service

Center.

To obtain a faster and more efficient reply when you

call the Center, state the model of the appliance

precisely, together with its serial number or

manufacturing number. This information is given on

the serial N° plate (Fig. 1) affixed to the rear of the

appliance and on the cover of this Instruction

Manual.

8 OPERATION

The appliance has a probe (19 Fig. 11) in the ice

container.

When the ice reaches the probe, a thermostat

automatically stops ice production.

When ice is taken from the container, the thermostat

will automatically reactivate ice-cube production,

thus creating a new supply of ice.

8.1

MODEL WITH CONTINUOUS SUPPLY (Fig.

12)

The appliance is equipped with an ice-cube

dispenser (24) on the front.

To take the required quantity of ice, place a glass

or a suitable container under the dispenser and

press the button (25) to turn on the supply.

Release the button (25) to stop the ice supply.

8.1.a ADJUSTING DISPENSED QUANTITY (Fig.

13)

All operations that require handling of

parts made of metal plate must be carried out

wearing suitable gloves to prevent cuts.

The operations described below must be

performed by a specialized technician, and only

after disconnecting the appliance from the