AQUASONIC AC339 Installationshandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Installationshandbuch für Redner AQUASONIC AC339 herunter. AQUASONIC AC339 10 Seiten. Underwater loudspeakers

Seite drucken

AQUASONIC IN-WALL INSTALLATION

This configuration requires some assembly. The Aquasonic® AC339 simply replaces the light bulb in the light niche.

TST

Float

Passive TST

Jam Nut

TST

Jam Nut

TST

Third-Party Light Niche (#4)

Pool Wall

Gasket Mounted onto Sound Lens

TST

Third-Party Light Niche (#4)

ASL

Passive TST

Float

ASL

Rubber Gasket (#3)

Pilot Screw

with Captive

Gum Washer

(#5)

ASL

Chrome Face Ring Assembly (#1)

TOOLS NEEDED: Phillips Head Screwdriver, 2-9/16" Open-Ended Wrenches.

1. Remove AC339 and acoustic sound lens (ASL) from packaging.

2. Seperate the TST from the float. Using the 9/16" wrenches,

loosen the jam nut to remove the float assembly from the gold

mounting point on the TST. Use one 9/16" wrench to hold the

TST's gold fastener, and with the second 9/16" wrench turn the jam

nut away from the gold mounting point until float and TST are

seperated.

3. Remove one jam nut from the threaded stud on float assembly.

Thread jam nut completely onto stud attached to acoustic

sound lens. You should now have two jam nuts threaded

completely on to the stud connected to the sound lens.

4. Fully thread acoustic sound lens onto TST. Using two wrenches

tighten jam nut against the mounting point. Using one wrench to

hold the TST's gold fastener, while the second tightens the

jam nut against the gold mounting point. Make sure that jam nut

is firmly tightened against the gold mounting point. This assembly

is now ready for installing into a third-party light niche.

IMPORTANT NOTE: DO NOT ASSEMBLE BY USING THE DOME

ITSELF TO TIGHTEN—MAKE SURE TO TIGHTEN THE TSTs BY

USING A 9/16" WRENCH ON THE GOLD HEX MOUNTING POINT

AND TURN THE JAM NUT USING A SECOND 9/16" WRENCH.

Please refer to page 5 for exploded diagram and part listing.

5. Remove rubber gasket (#3) from a third-party light niche

face ring assembly (#1) by loosening Phillips head screw on

unitension wire clamp (#2).

6. Wrap rubber gasket (#3) onto acoustic lens black rubber ring

then re-install (#3) with AC339 assembly installed into face

ring (#1). Tighten unitension wire clamp (#2).

7. Insert finished end of underwater speaker cable into conduit

opening in back of light niche (#4). Thread wire through

conduit to junction box.

8. Insert complete assembly into light niche back can (#4) using

pilot screw with captive gum washer (#5) to fasten chrome face

ring assembly (#1) to finish installation.

9. Connect supplied speaker wire to sound system amplifier by

connecting the red insulated wire to the positive terminal and the

black insulated wire to the negative terminal.

10. Adjust volume level—enjoy!

Aquasonic