AquaSure AS-F120PS Benutzerhandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Water Filtration Systems AquaSure AS-F120PS herunter. AquaSure AS-F120PS 12 Seiten. Whole house

Seite drucken

STEP 3.

Attaching the Water Supply Pipe

1. Wrap the 1" male threaded fittings (Not Included) with 5 to 6 wraps of Teflon tape.

2. Attached the 1" male threaded fitting from the incoming supply plumbing to the IN port

and OUT port of the system.

STEP 4.

Installing the Filter

1. Unwrapped the filter and place it inside the housing and make sure the housing is

centering on the stand pipe.

2. Screw on the housing with the filter inside and screw onto the corresponding head by

turning it counterclockwise using the supplied housing wrench.

Note: Make sure the o-ring is inside the housing and do not over tightening the housing.

STEP 5.

System Startup

WARNING! Immediately shut off the main water supply valve if there are leaks. Check the

leak area and see if there's a loose connection or if more Teflon tape is needed to prevent

leaks from happening.

1. Turn on the main water supply valve fully by turning it counterclockwise.

2. Check for leaks

3. Turn on the nearest faucet and let the water run for 10 minutes to release any trapped air

bubble or carbon fine if a carbon filter is installed.

CONGRATULATION!

Your system is ready to use. Please document the filter installation time and replace the filter in the

suggested replacement time.

www.AQUASUREUSA.com

Tel: 1-800-661-0680