Aquatec Elan Betriebsanleitung - Seite 6

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Wheelchair Aquatec Elan herunter. Aquatec Elan 17 Seiten.

Seite drucken
Bathlift (fig. 1) consisting of:
1
Sideflap
2
Seat plate
3
Battery guide with plug
4
Hand control
5
Drive unit cover
6
Curled cable for hand control
7
Backrest
8
Spindle
9
Spindle foot
10 Spindle foot retainer
11 Lifting scissors
12 Base plate
13 Gliding shoe
14 Track
15 Front suction cup (single strap with head)
16 Rear suction cup (double strap with thread)
Battery and charger (fig. 2)
2
Battery
5
Charger
Operating instructions (not illustrated)
Cover (optional)
Seat cover
Backrest cover
3.2

Technical data

Seat width with sideflaps folded out:
Seat width with sideflaps folded in:
Seat height at lowest position:
Seat height at highest position:
Maximum load:
Total weight without battery:
Weight of battery:
Weight of charger:
Operating voltage:
Charge time as from low-voltage warning: approx. 5 h
The label (fig. 11) provides important information.
The label is on the rear side of the backrest.
4

Transport

Important!
●
Do not remove the suction cups when
transporting the bathlift.
●
You may not transport the device with the
battery inserted into the guide on the back-
rest.
Take the battery out of the guide and only transport the
bathlift when it is folded together. For a description of
how to fold up the device, please refer to section 5.4.
5
5

Setting up

Important!
Before setting up, inspect all parts for damage
caused by transport.
5.1

Recharging the battery

Important!
●
●
1.
Insert the jack plug (1, fig. 2) of the charger (5,
fig. 2) into the socket (6, fig. 2) of the battery (2,
fig. 2).
2.
Insert the power plug (3, fig. 2) of the charger into
the power socket.
The red indicator lamp (4, fig. 2) on the charger stays
on until the battery is fully recharged.
700 mm
380 mm
3.
Pull the charger out of the power socket.
60 mm
4.
Disconnect the jack plug of the charger from the
420 mm
battery socket.
120 kg
11.7 kg
5.2

Attaching the suction cups

1.6 kg
0.5 kg
12 V
Important!
To detach the suction cups, follow these in-
structions in reverse order.
5.2.1

Preparing for assembly

1.
Place the lift on its side.
2.
Lift up the backrest slightly.
The locking mechanism between the base plate and
seat plate opens automatically.
3.
Carefully pull the base plate (12, fig. 1) and the
seat plate (2, fig. 1) apart.
The lift is now lying in a stable position on its side.
CAUTION!
There is a risk of injury from electric shock.
Only recharge the battery in dry rooms (not
in the bathroom).
Recharge the battery completely each time
before you use the bathlift.
Make sure that the voltage specifications
shown on the charger correspond to those
of the power mains.
CAUTION!
There is a risk of injury when the lifting scis-
sors move.
Do not reach between the lifting scissors
during assembly.
EN