Aquatec AQUAPRO AP2000 Gebrauchsanweisung
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Water Pump Aquatec AQUAPRO AP2000 herunter. Aquatec AQUAPRO AP2000 2 Seiten. Waterfeature pump
Seite drucken
IMPORTANT SAFEGUARDS
To guard against injury, basic safety precautions
should be observed including but not limited to
the following;
• The pump should only be used in clean
water. Do not use the pump in any solvent or
gasoline that is flammable.
• Do not operate the pump without water at
any time, permanent damage may occur.
• Do not operate the pump if the pump or any
of the components of the pump such as the
power cable have been damaged.
• If the plug does get wet, do not unplug the
cord. Disconnect the circuit breaker that
supplies power to the power point. Then
unplug and examine the plug and power point
for presence of water. If the power point has
become wet, you should consult an electrician
before using the power point again.
• Warning: Always use a properly grounded
power supply that is connected to an RCD
with a rated residual operating current
not exceeding 30mA. As per AS/NZS
3350.2.41:1997
• Always unplug the pump from the power
supply when not in use or before performing
any maintenance on the pump or in the
pond. Never pull the cord to disconnect the
plug from the power supply. Grasp the plug
and pull to disconnect.
• Do not install or store the pump where
it will be exposed to extreme hot or cold
temperatures.
• Keep out of reach of children or
pets. This appliance should not be used
by children or infirm persons without
supervision.
• Do not cut the cord as this will result in
voiding your warranty.
• Care should be taken to arrange the power
cord so that it cannot be accidently tripped
over or pulled.
• Do not attempt to repair the pump yourself.
Return to an authorized service centre or
place of purchase if a fault occurs.
• Do not use in water above 35°C.
Note: Please consult your retailer for quality original Aquapro replacement parts for your Aquapro
product. Visit www.aquatecequipment.com for nearest stockists.
www.aquatecequipment.com
LIMITED WARRANTY
• Warranty covers only appliance defects and
faulty material and workmanship within a 2
year period.
• If the pump fails due to a manufacturing fault
within the warranty period, the pump will be
either repaired or replaced free of charge.
• Faults arising due to; accidents, misuse,
not following manufacturer's guidelines/
instructions or power surges/spikes/
brownouts will not
be covered.
• The impellor set is a consumable item and
is therefore not covered under warranty.
Replacement parts are available form your
local retailer/ special orders.
• Warranty will be void if any tampering
removal of warranty labels or electrical
circuitry is evident.
• Warranty will be void if the power cord is cut
or damaged in any way.
• Warranty will be void if any visible signs of
overheating are present.
• The manufacturer or distributor shall not be
held responsible for any damages caused by
defective components or materials, or for loss
incurred because of the interruption of services
or any consequential or incidental damages or
expenses arising from the manufacture, sale,
use, or misuse of this product.
• Warranty claims caused by installation or
servicing faults will not be covered.
• It is the customer's responsibility to return
the faulty appliance for any warranty claim
to Aquatec.
• For any warranty to be valid, an original proof
of purchase must be provided.
• Our goods come with guarantees that
cannot be excluded under the Australian
Consumer Law. You are entitled to a
replacement or refund for a major failure and
for compensation for any other reasonably
foreseeable loss or damage. You are also
entitled to have the goods repaired or
replaced if the goods fail to be of acceptable
quality and the failure does not amount to a
major failure.
WATERFEATURE PUMP
instructions manual
MANuFACTureD FOr
PO Box 648, Maddington, Western Australia, 6989
Telephone (08) 9452 2444
email
www.aquatecequipment.com