Aquatec Aquapro AS10000DF Gebrauchsanweisung - Seite 2

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Water Pump Aquatec Aquapro AS10000DF herunter. Aquatec Aquapro AS10000DF 6 Seiten. Submersible sump pump

Seite drucken

Thank you for purchasing a quality AQUAPRO product!

VOLTS (V)

POWER (W)

MAXIMUM FLOW (L/H)

MAXIMUM HEAD HEIGHT (m)

MAXIMUM IMMERSION DEPTH (m)

MAXIMUM SOFT SOLID PARTICAL SIZE (mm)

OUTLET Ø (mm)

CABLE LENGTH (m)

DESCRIPtIon AnD FEAtURES

Your AQUAPRO sump pump has been

manufactured with advanced technology to provide

you with the best quality pump for extracting dirty

water from ponds, tanks and drains.

This product is not suitable for use with drinking

(potable) water and is not continuous rated.

An automatic float switch turns the pump on and off

as water levels rise and fall.

The pump has a convenient carry handle for

easy positioning.

InStALLAtIon

Screw the 90° elbow connector into the pump

housing in a clockwise direction. Tighten the

elbow firmly to prevent leakage.

2. Prepare the Multiple Hosetail Outlet;

it is designed to fit various hoses, pipes

and fittings. Three options (A, B & C) are

detailed below.

A. To fit a 25mm (1") tap adaptor (temporary

application only) Cut off the first 25mm

barbed section with a hacksaw directly in

front of the threaded section. It is now

ready to be fitted with a 25mm (1") tap

adaptor (not included).

B. To fit a 25mm hose.

No cutting is required; hose or tube is

now ready to be fitted.

C. To fit a 32mm hose.

Cut off the 25mm barbed and threaded

sections with a hacksaw leaving the

32mm barbed section only; hose or tube

is now ready to be fitted.

3. Screw the prepared Multiple Hosetail Outlet

clockwise onto the elbow, tightening firmly to

prevent leakage. Tubing or hose not to be

connected at this stage.

4. Fit hose or tube to the prepared Multiple

Hosetail Outlet and secure with hose clamp

(not supplied).

5. Unwrap the power cable and ensure the plug

is clear of wet damp locations.

6. If required the pump can be immersed in

deep water by using a rope secured to the

carry handle.

7 .

Adjusting the Float Switch. The float switch

allows you to adjust the switching On and Off

depending on the application requirements.

The float switch can also be set to run

continuously.

A. Automatic Mode

In automatic mode float heights can be

adjusted between 500 and 150mm. To

control the automatic on/off switching at

various water levels, simply reduce or

increase the length of the float switch

cable by inserting the cable into the

circular groove (Float Switch Adjuster) on

the side of the carry handle.

AS10000DF

240

550

10000

7 .0

25|32