Panasonic BMET500 - CAMERA HEAD UNIT Betriebsanleitung - Seite 9

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Digitalkamera Panasonic BMET500 - CAMERA HEAD UNIT herunter. Panasonic BMET500 - CAMERA HEAD UNIT 24 Seiten. Iris camera

Seite drucken

PRECAUTIONS

• Refer all work related to the installation of this

product to qualified service personnel or system

installers.

Consult an expert on the load bearing capacity of the

installation surface and structure. If the surface is not

strong enough, the camera may fall down. Refer to the

product specifications for weights.

• Do not drop metallic parts through slots.

This could permanently damage the appliance. Turn

the power off immediately and contact qualified service

personnel for service.

• Do not attempt to disassemble the appliance.

To prevent electric shock, do not remove screws or

covers.

There are no user-serviceable parts inside. Contact

qualified service personnel for maintenance.

• Handle the appliance with care.

Do not strike or shake, as this may damage the appli-

ance.

• Do not expose the appliance to water or moisture.

Do not try to operate it in wet areas.

Take immediate action if the appliance gets wet. Turn

the power off and refer servicing to qualified service

personnel. Moisture can damage the appliance and

also cause electric shocks.

• Do not use strong or abrasive detergents when

cleaning the appliance body.

Use a dry cloth to clean the appliance when it is dirty.

When the dirt is hard to remove, use a mild detergent

and wipe gently.

• Do not operate the appliance beyond its specified

temperature, humidity, or power source ratings.

Use the appliance at temperatures between 0 °C and

40 °C {between 32 °F and 104 °F} and humidity

between 30 % and 80 %. The input power source for

this appliance is 32 V DC (when supplied from the con-

trol unit) or 24 V DC (when supplied from an external

power supply device).

• This unit has no power switch.

Power is supplied from Control Unit BM-ED500 or from

an external 24 V DC power supply device. Refer to the

control unit's operating instructions for how to turn

on/off the power.

• When you use an external power supply device, do

the following:

Turn on the external power supply device before turn-

ing on Control Unit BM-ED500.

Turn off the external power supply device after turning

off the control unit.

• The third-party external power supply must be a UL

Listed access control power limited device.

• Consumable part

Contact your dealer for the front panel replacement, for

example, when it is damaged or when you cannot rec-

ognize or enroll yourself.

Part number of the front panel: 3CF001017AAA

• Use of near-infrared ray

Near-infrared ray is used when iris data is enrolled or

recognized by the unit. The near-infrared ray is compli-

ant with the radiological safety standard of IEC60825-1.

• Indication

Refer to the bottom of the unit as to the indications of

equipment classification and power source, etc.

• This product is not designed to prevent theft in

advance. We shall not guarantee you for any trouble

caused by using this unit.

• If you are in a situation that iris recognition is

impossible from the exterior, recognition or

enrollment will be invalid.

• Iris data is privacy. Take enough care not to leak the

image data out of the administration PC. It is also

recommended that you should get an agreement

from a person to register his or her data.

• We recommend that you note down your settings

and save them. Power or battery failure may erase

the setting.

• Do the self-diagnostic test, when you open this unit

door for maintenance, etc. The self-diagnostic test

can be carried out by turning on a power supply.

Read BM-ED500 Operating instructions for turning on a

power supply.