HP 1810-24 Handbuch zur Schnelleinrichtung

Blättern Sie online oder laden Sie pdf Handbuch zur Schnelleinrichtung für Schalter HP 1810-24 herunter. HP 1810-24 4 Seiten.

HP 1810-24 and 24G Switch Quick Setup Guide

The switch drawings in this document are for illustration only and may not match your particular switch model.

For more detailed instructions and information to set up your switch, view or download the Installation and Getting Started

Guide for your switch at www.hp.com/networking/support.

Unpack and check included parts.

Prepare for installation. To avoid personal injury or product damage, review the "Safety Precautions" on

page 4.

. Power on and verify that Self-Test completes normally. The switch does not contain a power switch. It is turned on

by connecting power through the AC power cord.

Mount the switch. Unplug the AC power from the switch before mounting it.

Rack Mounting: Use a #1 Phillips (cross-head) screwdriver to attach the accessory kit brackets to the switch using the

eight 8-mm M4 screws. Then use the four number 12-24 screws to secure the brackets to the rack.

Table or Desktop Mounting: Attach the four self-

adhesive pads (included in the accessory kit) to the

bottom corners of the switch.

Documentation kit

■

Switch

■

Accessory kit (installation hardware)

■

AC power cord

■

After Self-Test:

Power LED = On

Fault LED = Off