HP 316095-B21 - StorageWorks Edge Switch 2/24 Freigabemitteilung - Seite 5

Blättern Sie online oder laden Sie pdf Freigabemitteilung für Schalter HP 316095-B21 - StorageWorks Edge Switch 2/24 herunter. HP 316095-B21 - StorageWorks Edge Switch 2/24 23 Seiten. Edge switch release notes
Auch für HP 316095-B21 - StorageWorks Edge Switch 2/24: Handbuch aktualisieren (9 seiten), Handbuch (41 seiten), Handbuch (40 seiten), Freigabemitteilung (32 seiten), Freigabemitteilung (27 seiten), Handbuch (26 seiten), Freigabemitteilung (27 seiten), Freigabemitteilung (25 seiten), Installationsanleitung Handbuch (24 seiten), Freigabemitteilung (23 seiten), Freigabemitteilung (23 seiten), Freigabemitteilung (22 seiten), Freigabemitteilung (19 seiten), Freigabemitteilung (19 seiten), Freigabemitteilung (18 seiten), Anleitung Handbuch (17 seiten), Freigabemitteilung (17 seiten), Upgrade-Anweisungen (16 seiten), Anleitung Handbuch (16 seiten), Installationsanleitung Handbuch (16 seiten), Freigabemitteilung (16 seiten), Freigabemitteilung (17 seiten), Freigabemitteilung (17 seiten), Freigabemitteilung (11 seiten)

ation is subject to change, contact your HP-authorized service representative for the current number

of ISLs supported for each Edge Switch or Director.

Hop count—The hop count is equal to the number of ISL connections traversed in a single path,

not the total number of ISL connections between devices. The Fibre Channel theoretical limit of ISL

connections traversed (hop count) in a single path through a fabric is seven. The maximum supported

hop count in a single path through a fabric is three. Because this information is subject to change,

contact your HP-authorized service representative for the current hop count supported by a single

fabric path.

NOTE:

For more information about planning the fabric, see the HP StorageWorks SAN design reference

guide , available on the following HP website:

http://www.hp.com/go/SANdesignguide

Cable requirements

Consider the following switch cable requirements.

For cables measuring up to 500 meters (1 Gb/s) or 300 meters (2 Gb/s), use multimode Fibre

Channel cables. For longer cables, use single-mode Fibre Channel cables.

Multimode optical cables are connected to short-wave optical transceiver modules in a switch.

Single-mode optical cables are connected to long-wave optical transceiver modules in a switch.

Multimode cables should use 50/125 optical fibers; single-mode cables typically use 9/125 op-

tical fibers for distances up to 10 km.

Verify that connectors interfacing with the Edge Switch or Director products use LC duplex connectors

with a PC finish. The connector at the opposite end of the cable must be of either LC or SC type,

depending on the requirements of the connected device.

For a list of supported operating systems, see the HP StorageWorks SAN design reference guide,

available on the following HP website:

http://www.hp.com/go/SANdesignguide

Languages

English

Director and Edge Switch release notes (09.08.03)