AQUATECH EDGE Gebrauchsanweisung - Seite 5
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Kamera-Zubehör AQUATECH EDGE herunter. AQUATECH EDGE 9 Seiten. Sport housing
Auch für AQUATECH EDGE: Gebrauchsanweisung (5 seiten)
Seite drucken
Initial setup
•
After removing your housing from the box, place it
face down on a soft level surface.
•
Proceed to unlock the Safety Clips one by one by
pressing the safety latch to the right(when the
back plate is facing up), and pulling the clip up to
release it from the body of the housing. Now repeat
the process with the second clip, and remove the
backplate. *IMPORTANT: BE CAREFUL NOT TO
DROP YOUR BACKPLATE WHILE UNLOCKING
YOUR CLIPS.
•
Perform a quick inspection of the inside of the
housing to ensure the camera plate and cable
release are installed and ready for use.
•
Next, inspect your Backplate. The main camera
controls are located here. The push button controls
are adjustable to suit the camera by winding out the
black tips on the inside of the backplate. You can
increase or decrease sensitivity this way. Keeping
the Backplate clean will also help when reviewing
images.
•
To reinstall your Backplate place the Swivel Hooks at
11 o clock, located at the bottom of the Backplate on
the Hinge Pins and proceed to close and secure your
backplate, making sure your two clips are firmly
locked.
Installing your Camera Plate
•
When receiving your AquaTech housing remove the
camera plate from the mount by sliding the camera
plate towards you.
•
Double check the camera plate is correct and
includes a 1/4"-20 screw. Each camera plate has the
camera model it suits engraved on the top side. To
install the camera plate on your housing you will
need a flat head screwdriver.
•
Lineup the top side of the camera plate to the
bottom of your camera ensuring the screw hole
opening on the camera plate is lined up with the
tripod mount thread under the camera body.
•
Screw in the camera plate screw and tighten it to
the right until you feel some resistance, be careful
not to over tighten the bolt.
Installing the cable release
•
Inside the housing you will find a cable release
connected to a PCB board on the left hand side.
Be sure the cable release is fully plugged into the
female end on the PCB board. The male end of the
cable release will be plugged into the remote control
input on your camera. Each camera has a different
spot for this input, most times you will find this input
on the left hand side of the camera.
•
Ensure the cable release is fully plugged into the
camera. This will now enable the electronic shutter
buttons and pistol to activate your camera shutter
to focus/fire or start/stop video.
What the grease is used for:
•
The main purpose for the grease provided is to
keep the controls and shafts on your Sport Housing
working nice and smooth, as well as to grease the
inner O- Rings
4