HP ProCurve J4862A Handbuch installieren - Seite 16
Blättern Sie online oder laden Sie pdf Handbuch installieren für Schalter HP ProCurve J4862A herunter. HP ProCurve J4862A 36 Seiten. Procurve switch gl modules
Seite druckenInstalling the GL Modules
100/1000-T GL Module
twisted-pair
cable with
RJ-45 connector
Note: In the module's default configuration, Auto, either a straight-through or crossover cable can be used to connect
the module to either another Gigabit device or to a 100Base-T device. See the Note on Automatic Cable Sensing on
page 11.
mini-GBIC GL Module
fiber-optic cable
with
LC connector
Notes:
Gigabit-LX – If multimode cable is used, a mode conditioning patch cord may be needed — see "Mode Conditioning
Patch Cord" on page 24 for more information.
Gigabit-LH – Between the transmit and receive ends of the cable, at least 5dB of attenuation is required for a reliable
connection. This is equivalent to 20Km of the fiber-optic cable. For distances less than 20Km, you must add attenuators
to bring the total attenuation to at least 5dB. Most cable vendors carry attenuators.
10
Module
RJ-45 ports with
"Auto MDI/MDI-X"
Gigabit-LX or Gigabit-SX
mini-GBICs
Continued on the next page.
Cable Type
100 Mbps operation:
category 5, 100-ohm
differential twisted-pair
cable
1000 Mbps (Gigabit)
operation: category 5E,
100-ohm cable is
recommended, although
category 5 cable may also
work.
Gigabit-SX operation:
multimode fiber-optic
cables that are fitted with
LC connectors
Gigabit-LX operation:
single-mode fiber-optic
cables fitted with LC
connectors.
multimode fiber-optic
cables may also be
used—see "Fiber-Optic
Cables" on page 23.
Gigabit-LH operation:
the same single-mode
cables as for Gigabit-LX.
Maximum Length
100 meters
100 meters
220 meters to 550
meters, depending on
the cable used. See
"Fiber-Optic Cables"
on page 23 for more
information.
• single-mode cable:
10 kilometers
• multimode cable:
550 meters
70 kilometers