HP ProCurve J4893A Installationshandbuch - Seite 20
Blättern Sie online oder laden Sie pdf Installationshandbuch für Schalter HP ProCurve J4893A herunter. HP ProCurve J4893A 38 Seiten. Switch gl modules
Auch für HP ProCurve J4893A: Handbuch installieren (36 seiten)
Seite drucken
Customizing the Port Configuration
If the slot in which you installed the module was empty the last time the switch
was either rebooted or reset (or the power to the switch was cycled), then the
module will use preconfigured default parameter values that will work for
most networks.
The default port configurations for the modules are:
Ports Enabled: Yes
■
■
Mode:
•
10/100-TX gl Module: Auto — The port auto negotiates speed (10 or
100 Mbps), communication mode (half or full duplex), and MDI or
MDI-X port operation. Note: if you configure the port to one of the
fixed 100 Mbps modes, the port will then operate only as an MDI-X
port.
100/1000-T gl Module: Auto — The port auto negotiates speed (1000
•
or 100 Mbps), communication mode (half or full duplex), and MDI or
MDI-X port operation. Note: if you configure the port to one of the
fixed 100 Mbps modes, the port will then operate only as an MDI-X
port.
10/100/1000-T gl Module: Auto — The port auto negotiates speed
•
(10, 100 or 1000 Mbps), communication mode (half or full duplex),
and MDI or MDI-X port operation. Note: if you configure the port to
one of the fixed 100 Mbps modes, the port will then operate only as
an MDI-X port.
•
Gigabit-SX and Gigabit-LX ports in Gigabit Transceiver gl
Module and mini-GBIC gl Module: Auto — The ports always
operate at 1000 Mbps and full duplex. The setting is Auto for best link
establishment with other devices.
•
Gigabit-LH ports in the mini-GBIC gl Module: Auto — The port
always operates at 1000 Mbps and full duplex. The setting is Auto for
best link establishment with other devices.
100-FX MTRJ gl Module: 100FDX — The port operates at 100 Mbps
•
and full-duplex communication mode.
Flow Control: Disabled
■
Installing the gl Modules
13