HP StorageWorks 7110 - Virtual Array Anweisungen - Seite 3

Blättern Sie online oder laden Sie pdf Anweisungen für Schalter HP StorageWorks 7110 - Virtual Array herunter. HP StorageWorks 7110 - Virtual Array 4 Seiten. Private loop (hubs/direct connect)
Auch für HP StorageWorks 7110 - Virtual Array: Handbuch verwenden (34 seiten), Upgrade-Anweisungen (12 seiten), Handbuch (4 seiten), Handbuch (4 seiten), Einbauanleitung (2 seiten), Handbuch (2 seiten), Handbuch (1 seiten), Handbuch (1 seiten)

Seite drucken

HP StorageWorks 7110 - Virtual Array Anweisungen

NOTE: Before proceeding, notice that there are two

locating pins inside the bottom of the cover. See

locating pins in Figure 4.

With the power button down, lower the array chassis

into the cover.

Be sure that the rear of the array chassis is flush with

the rear side of the cover, then slide it down and over

the two locating pins (Figure 4).

With the cutout on the base facing the front, lower the

base onto the array chassis. Then slide the four locator

pins on the base into the four holes on the outside of

the array chassis (Figure 5).

10. Using the Torx T25 driver, install and tighten the eight

M5 screws on the base (Figure 5).

a. Secure the base to the

screws.

b. Secure the base to the

M5 screws.

with four of the M5

cover

with four of the

array chassis

Power Button

Figure 4

Front slots

on base

Figure 5

Locating pins