HP StorageWorks 8/24 - SAN Switch Freigabemitteilung - Seite 24

Blättern Sie online oder laden Sie pdf Freigabemitteilung für Schalter HP StorageWorks 8/24 - SAN Switch herunter. HP StorageWorks 8/24 - SAN Switch 30 Seiten. Hp storageworks fabric os 6.1.2b release notes (5697-0351, march 2010)
Auch für HP StorageWorks 8/24 - SAN Switch: Spezifikationen (20 seiten), Freigabemitteilung (29 seiten), Freigabemitteilung (32 seiten)

Seite drucken

HP StorageWorks 8/24 - SAN Switch Freigabemitteilung

Fabric OS 6.1.0b fixes

Table 8

lists defects closed in the Fabric OS 6.1.0b firmware release.

Table 8 Fabric OS 6.1.0b closed defects

Closed defect summary

I2C response failure and subsequent reset will occasionally result in

DC Director fan fault errors.

When running stressful SAK IRNDUP to CUP tests, user may observe

Intermittent Channel Timeouts.

In a FICON Extender environment in which a host path goes offline,

the switch does not link time-out the F_Port.

HP StorageWorks 400 Multi-protocol Router: If there are multiple Initi-

ators fanned into a single FCIP fastwrite tape target, the tape may be

marked prematurely as full.

When physically replacing an N_Port device with an ISL in a soft zone

configuration, a DC SAN Director panic occurs.

Traffic Isolation failover policy reverts back to "disabled" from "en-

abled" after changing the port membership list.

Potential timeouts and aborts during Device Discovery and CU busy

processing when using FICON XRC Emulation.

Integrated Routing with multiple ports in an Ex_Port trunk, may not

properly send an entire exchange on the same link.

FICON CUP reports incorrect Director Size Code in Basic Sense and

Sense ID data for HP StorageWorks 8/40 and 8/80 SAN Switches.

FICON Channel continuously sends RRQ frames for approximately 20

seconds before aborting.

If QoS and Diff Serv are enabled, some FCIP tunnels may not come

online in the case of an 8 to 1 fan-in scenario.

When the proxy device projected to the backbone has a translate

domain of greater than 0x20, the router is not properly translating the

ACC for a REC. Traffic is interrupted and the tape device fails.

HP StorageWorks 8/80 SAN Switch fan module can be marked faulty

after multiple and repeated removals/reinsertions.

Solution

Fixed in Fabric OS 6.1.0b