HP StorageWorks XP12000 Konfigurationshandbuch - Seite 12

The following host group mode (option) is available for Tru64:

Table 2 Host group mode (option)

Host

Group

Mode

Function

Enable use of XP Continuous Access Software

on Tru64 TruClusters.

CAUTION:

Changing host group modes for ports where servers are already installed and configured breaks all

LUN paths and will require the paths to be redefined. See

group mode 14 is applied to an existing LUN, Tru64 will need to be installed again. If XP Continuous

Access is going to be used, the host group mode must be set before the installing Tru64.

Setting the System Option Modes

The HP service representative sets the System Option Mode(s) based on the operating system and

software configuration of the host. Notify your HP representative if you install storage agnostic software

(such as backup or cluster software) that may require specific settings.

Configure the disk array Fibre Channel ports by using Remote Web Console (shown), or XP Command

View. Select the settings for each port based on your storage area network topology. Use switch

zoning if you connect different types of hosts to the array through the same switch. For detailed

procedures, refer to HP StorageWorks XP LUN Manager User's Guide available at:

http://www.hp.com/support/manuals.

Installing and configuring Tru64 for the XP disk array

Default

Comments

Previously MODE272

Inactive

"Defining the

paths" on page 16. If host