HP surestore fc 2Gb entry switch 8B Handbuch - Seite 22

Blättern Sie online oder laden Sie pdf Handbuch für Schalter HP surestore fc 2Gb entry switch 8B herunter. HP surestore fc 2Gb entry switch 8B 50 Seiten. Fabric os procedures guide (version 3.0)

Seite drucken
2
Basic Configuration Procedures

Displaying whether Track Changes is Enabled

To display the status of the track changes feature:
1.
Login to the switch as the admin user.
2.
At the command line enter the following command:
trackChangesShow
The status of the track changes feature is displayed as either on or off. This also displays
whether the track changes feature is configured to send SNMP traps. For example:
switch:admin> trackchangesshow
Track changes status: ON
Track changes generate SNMP-TRAP: NO

Configuring a Static Route Between Two Ports

To configure a static route between two ports:
1.
Login to the switch as the admin user.
2.
At the command line enter the following command:
uRouteConfig port, domain, outputport
where port is the port to be statically routed; can be either an F_port or an E_port., domain
is the domain ID of the specified target switch, and outputport is the output port where
traffic is to be forwarded.
After this command is issued, and if outputport is a usable port, all frames coming in from
a specified port addressed to the specified domain are routed through the specified
outputport.
If the outputport is not usable, the routing assignment is not affected. When
outputport becomes usable the static route assignment for the port is enforced.
Note:

Configuring the In-order Delivery Option

In a stable fabric, frames are always delivered in order, even when the traffic between switches is
shared among multiple paths. However, when topology changes occur in the fabric (for instance, a
link goes down), traffic is rerouted around the failure. When topology changes occur, some frames
may be delivered out of order.
The default behavior enables out-of-order delivery of frames during fabric topology changes. This
enables fast rerouting after a fabric topology change.
2-8
Using static routes can affect load sharing. If a large number of routes are statically
configured to the same output port, the ability of the switch to achieve optimum load
sharing may be impaired.
Fabric OS Procedures Guide