HP XP20000/XP24000 Konfigurationshandbuch - Seite 15

Blättern Sie online oder laden Sie pdf Konfigurationshandbuch für Schalter HP XP20000/XP24000 herunter. HP XP20000/XP24000 38 Seiten. Hp storageworks xp disk array configuration guide: vmware (a5951-96106, september 2010)
Auch für HP XP20000/XP24000: Freigabemitteilung (13 seiten), Integrationshandbuch (29 seiten), Freigabemitteilung (4 seiten), Handbuch für Administratoren (50 seiten), Konfigurationshandbuch (42 seiten), Konfigurationshandbuch (40 seiten), Konfigurationshandbuch (40 seiten), Konfigurationshandbuch (36 seiten), Konfigurationshandbuch (36 seiten), Konfigurationshandbuch (30 seiten), Konfigurationshandbuch (36 seiten), Freigabemitteilung (5 seiten), Konfigurationshandbuch (46 seiten), Konfigurationshandbuch (46 seiten), Referenzhandbuch (46 seiten), Konfigurationshandbuch (40 seiten), Konfigurationshandbuch (44 seiten), Konfigurationshandbuch (34 seiten), Konfigurationshandbuch (30 seiten), Konfigurationshandbuch (30 seiten)

Seite drucken
HP XP20000/XP24000 Konfigurationshandbuch
5.
Right-click the selection and then select Set UUID. The Set UUID window will be displayed (see
Figure
3).
Figure 3 Set UUID window
.
6.
Enter a UUID in UUID in the Set UUID window. When a OpenVMS server host is used, a UUID
can consist of the numerical value between 1 to 32,767.
7.
Click OK to close the Set UUID window.
8.
Click Apply in the LUN Manager window. A message appears asking whether to apply the
setting to the storage system.
9.
Click OK to close the message. The settings are applied to the storage system and the UUID is
set.
CAUTION:
The correct host mode must be set for all new installations (newly connected ports) to OpenVMS hosts.
Do not select a mode other than 05 for OpenVMS. Changing a host mode after the host has been
connected is disruptive and requires the server to be rebooted.

Setting the system option modes

The HP service representative sets the system option mode(s) based on the operating system and
software configuration of the host. Notify your HP representative if you install storage agnostic software
(such as backup or cluster software) that may require specific settings.

Configuring the Fibre Channel ports

Configure the disk array Fibre Channel ports by using P9000 or XP Command View Advanced Edition
Software or XP Remote Web Console (shown). Select the settings for each port based on your storage
area network topology. Use switch zoning if you connect different types of hosts to the array through
the same switch.
XP Disk Array Configuration Guide: OpenVMS
15