aQuatell Fleck 5600SXT Anleitung Handbuch - Seite 11

Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Wasserspender aQuatell Fleck 5600SXT herunter. aQuatell Fleck 5600SXT 15 Seiten.

Metal clips hold the bypass to the turbine. Simply push the bypass onto the turbine assembly and

tighten down the metal clips. These clips do not need to be overtightened.

Putting it all together - Plumbing Your Softener

The plumbing adapters for the Fleck valve are either 1" or 3/4" male or female threads. When

connecting to the plumbing adapter threads, two or three passes of teflon tape should be used on

the male threads. Ensure all local plumbing codes are adhered to when connecting the softener

to your plumbing. When facing the front of the water softener, the inlet to the softener is on the

right, and the outlet is on the left. Ensure you route your plumbing accordingly. The inlet/outlet

is also labelled on the bypass itself.

Putting it all together - Filling the Softener with Water

Now that your softener is plumbed in place, you need to direct your hard water into the softener

to fill it and of course to begin producing soft water for your home. Before doing anything else,

make sure your softener is in the bypass mode. For all plastic bypasses you'll know if you're in

bypass mode if both plastic knobs (one for inlet, one for outlet) are turned so that they're

perpendicular to the plumbing. There also arrows and words on the bypass that will show you

what position is the bypass position.

Once you're in bypass mode, open your water main back up. Where your plumbing enters and

exits the bypass you'll want to have a quick look for leaks. If nothing is leaking, slowly open the

inlet side of the bypass. Once this is open all the way, open the outlet side of the bypass just a

crack. You will hear water trickling into the softening tank. The idea is to slowly fill the

softening tank with water. Once the softening tank is full, open the outlet side of the bypass all

the way. The bypass valve should now be fully open on both the inlet and outlet sides.

Your water softener is now in service mode and you will begin to get softened water immediately

as the resin comes pre-charged. The final step in setting up your new water softener is to

program the valve to your conditions.

Programming your water softener - Before you Begin

Now that your softener is plumbed, it must be programmed to your specific conditions. In order

to properly program your softener you will need to know your water hardness in Grains per

Gallon (gpg) and the capacity of the softener you ordered. It is also useful to know how much

iron is present in the water. The softener can be programmed in two ways.

Page 11

Fleck 5600SXT U.S. V1.1