Diamond Tech Prism Suncatcher Schnellstart-Handbuch - Seite 3

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Heimbeleuchtung Diamond Tech Prism Suncatcher herunter. Diamond Tech Prism Suncatcher 3 Seiten.

Seite drucken

of the suncatcher upside down and dangle the chain until the jump ring touches the inner middle part of

the top suncatcher. Drop a small amount of liquified solder, connecting the two pieces together.

12. Wash thoroughly using warm water and soap and a soft brush. Clean both sides then rinse well and

dry.

Optional:

• Add black or copper patina following manufacturer's instructions.

• Tie ribbon scraps to the jump ring and add a loop of micro filament to hang the suncatcher with.

SOLDERING TIPS: (Here are some hints)

• If solder doesn't flow smoothly—apply more flux.

• If seams bulge over the glass— there's too much solder; you may need to melt and pull off the excess.

• If solder spits or bubbles there's too much flux; wipe some off.

• Flat seams need more solder.

• Don't stay in the same spot too long or the solder will bleed through or the glass will crack.

• Wipe your iron tip frequently on a wet sponge while you are soldering.

• Re-tin your tips as needed using a sal-ammoniac block.