Diamond Tech International Power Miter II Betriebshandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Säge Diamond Tech International Power Miter II herunter. Diamond Tech International Power Miter II 9 Seiten. Chop saw

Seite drucken

Keep Children Away.

• Keep all visitors a safe distance from the miter saw.

• Make sure bystanders are clear of the miter saw and workpiece.

Don't Force Tool.

• It will do the job better and safer at its designed rate. Feed the saw into the workpiece only fast

enough to let the blade cut without bogging down or binding.

Before freeing jammed material:

• Turn switch "OFF".

• Wait for all moving parts to stop.

• Unplug the miter saw.

After finishing a cut:

• Release the switch, and wait for all moving parts to stop before moving your hands.

Before Leaving The Saw

• Never Leave Tool Running Unattended.

• Turn switch off.

• Wait for all moving parts to stop.

• Unplug the miter saw.

• Make workshop child-proof. Lock the shop. Disconnect master switches. Store tool

away from children and others not qualified to use the tool.

Motor Specifications and Electrical Requirements

Power Supply and Motor Specifications

WARNING: To reduce the risk of electrical hazards, fire hazards, or damage, or damage to

the tool, use proper circuit protection. Your saw is wired at the factory for operation using the

voltage shown. Connect tool to a power line with the appropriate voltage and 15-amp

branch circuit. To reduce the risk of shock or fire, if power cord is worn or cut, or damaged in

any way, have it replaced immediately.

Voltage

Hertz (Cycles)

Watts

RPM

Shaft Rotation (blade end)

Brake

Motor Safety Protection

1. If the motor won't start, release the trigger switch immediately and unplug the tool. Check

the saw blade to make sure it turns freely. If the blade is free, try to start the motor again. If

the motor still does not start, refer to the "Motor Trouble-Shooting Chart."

2. If the motor suddenly stalls while cutting, release the trigger switch, unplug the tool, and

free the blade. The motor may now be restarted and the cut finished.

3. Fuses may "blow" or circuit breakers may trip frequently for the following reasons:

a. Motor Is Overloaded-Overloading can occur if you feed too rapidly or make too

many start/stops in a short time.

b. Improper or dull saw blade is used.

Safety Instructions for Miter Saw

110V

250

8000

Clockwise

Automatic