Panasonic PT-L6510E Betriebsanleitung - Seite 37
Blättern Sie online oder laden Sie pdf Betriebsanleitung für Projektor Panasonic PT-L6510E herunter. Panasonic PT-L6510E 50 Seiten. 3600 ansi lumens sxga lcd projector 4200 ansi lumens xga lcd projector
Auch für Panasonic PT-L6510E: Broschüre & Specs (6 seiten)
Seite drucken
Using the SERIAL
The projector is equipped with an RS-232C standard serial terminal at the rear. It is therefore possible to connect it
to a computer for control.
Connection
• Single
Side interface panel
D-sub 9-pin (female)
SERIAL
D-sub 9-pin (male)
Pin assignments and signal names
D-Sub 9-pin (female)
external appearance
Communication
requirements
Basic format
Transmission from the computer begins with STX, then the command, parameter and ETX are sent in this order.
Colon (:) is not required when transmitting the command which does not need a parameter.
STX
AD
Start
Caution
• On commencement of lamp lighting, commands cannot be sent or responses received for approximately 10
seconds. Be sure to send any commands and receive responses 10 seconds. (Applies to the PT-L6600E /
PT-L6600EL only)
• When transmitting several commands, wait for a response from the projector before sending the next command.
When sending commands without parameters, a colon is not necessary.
• When it is unnecessary to designate an ID code, send the format without the part to ID designate it.
Note
• If a wrong command is received, the projector sends ER401 back to the computer.
• When using control from the remote terminal, commands cannot be received at the serial terminal.
• Projector ID supported on the RS-232C interface is 0 (ALL) to 99.
• The remote control ID is set from 0 to 3. If a command is sent with a projector ID specified, the projector will return
answer back only if the ID contained in the command matches the projector ID or the projector ID is set to ALL.
PC
Communication cable
Description
Pin No. Signal name
NC
Send data
TXD
Receive data
RXD
Connected internally
Ground
GND
NC
CTS
Connected
internally
RTS
NC
Signal level
Sync method
Baud rate
Parity
Character length
Stop bit
X parameter
S parameter
I 1
I 2
:
C1
ID characters
(2 Bytes)
Colon
Command 3 characters
00 to 99
ID designate
Unit 1 interface panel
D-sub 9-pin
• Plural
(female)
IN
PC
SERIAL
D-sub 9-pin
(male)
Communication cable
D-Sub 9-pin (male)
external appearance
Start-stop transmission
C2
C3
:
P1
Colon
(3 Bytes)
Unit 2 interface panel
D-sub 9-pin
D-sub 9-pin
(male)
(female)
OUT
IN
SERIAL
D-sub 9-pin
D-sub 9-pin
(male)
(female)
Communication cable
Pin No. Signal name
RXD
TXD
GND
RTS
CTS
RS-232C
9 600 bps
None
8 bit
1 bit
None
None
P2
P3
P4
P5
Parameter
(1 to 5 Bytes)
D-sub 9-pin
(male)
OUT
Description
NC
Receive data
Send data
NC
Ground
NC
Connected
internally
NC
ETX
End
37