Diamond Tools SawMaster SDT-410 Benutzerhandbuch - Seite 2
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Säge Diamond Tools SawMaster SDT-410 herunter. Diamond Tools SawMaster SDT-410 6 Seiten. Hand held saw
Seite druckenFIGURE 1
1.
2.
Adjusting the Cutting Depth
1. To adjust the saw's cutting depth, loosen the bolt (3).
2. Move the base plate (4) to the desired depth and tighten the bolt.
3. The distance that the blade (8) protrudes from the base of the saw is the saw's cutting
depth.
Carbon Brush Replacement
1. Loosen 4 screws from rear of Carbon Brush Motor and remove the black plastic cover.
2. Loosen the cap counter clockwise from each side of the Carbon Brush Housing, then remove
the used Spring carbon brushes and replace with new carbon brush.
3. Reverse the unpacking procedure after you install the new carbon brush and tighten the housing brush cap.
Adjusting the Cutting Angle
1. The saw can be adjusted to cut at angle between 0° and 45°.
2. Loosen the nut (5) of the scale (6) and tilt the base plate (4) to the desired angle.
3. At the desired angle, re-tighten the nut so the position is secure.
NOTE: Adjustments to the saw should not be made while the saw is running!
Replacing the Diamond Blade
1. Loosen the bolt (11)
with the wrench set provided (12)
2. Remove the blade (8) from the inside flange and drive shaft.
3. Place the new blade so that it is against the inside flange on the driving shaft.
4. Now place the outside flange against the blade and tighten the bolt firmly with the wrench
set (12). (Direction A is to tighten, while direction B is to loosen the bolt.)
NOTE: The machine should be unpowered during this operation (unplugged)!
The blade markings should be visible from the outside.
Mounting the Watering Device
1. Loosen the bolt (3), and lower the base plate (4) as far as possible and tighten the bolt.
2. Set the water-device (15) with the provided screws (16).
3. Connect the end of the provided pipe to a water source (tap).
4. Turn on the tap to water the blade.
5. Use the adjustment lever (18) to adjust the amount of water. Position "A" is open and "B"
is closed.
NOTE: Make sure the water outlet (14) is not touching the blade.
Operating
Figure 7
To make precise cuts, pencil the desired cuts and follow the line using the edge (19) of the
base plate to follow the line. To initiate the cut, place the saw so that blade does not yet touch
the work piece and activate the saw. When the blade reaches its apparent maximum rpm, push
the machine forward to begin the cut. The machine should be pushed with uniform and even
pressure while performing the cut.
NOTE: While cutting, be sure to wear rubber gloves and insulated foot wear to
prevent electric shocks.
FIGURE 2
3.
8.
4.
, and remove the outside flange.
FIGURE 3
Step 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Continue Next Page...
Step 2
6.
4.
5.
FIGURE 4
12.
8.
11.
B
A
FIGURE 5
FIGURE 6
A
16.
B
18.
3.
15.
14.
FIGURE 7
14.
7.
13.
4.