Panasonic RX-C52 Betriebsanleitung - Seite 14

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Stereo System Panasonic RX-C52 herunter. Panasonic RX-C52 21 Seiten. Portable stereo component system

Seite drucken
ONE PROGRAM
REPEAT
Upon completion of the playback of one program, the tape is
rewound automatically to the beginning of the program, and
playback is repeated continuously.
1) Set the unit in the playback mode.
2) Set the One Program
Repeat Button to 'm= ON".
When not in using the ONE PROGRAM REPEAT, set
the One Program Repeat Button to "Ml OFF".
When the playback of that selection is completed, the
tape will be automatically rewound to the beginning of
the selection, and playback will begin again; this process
will be repeated continuously.
To cancel the one program repeat operation, set the One
Program Repeat Button to ''#l OFF". The unit will return
to the normal playback mode.
During operation of the one program repeat function,
power to the unit will not be cut off even if the Power
Switch is switched to 'Ml OFF/SLEEP".
3)
4)
Pras ee
Non-recorded
Raa
leds ey
direction
Non-recorded
4
ms
Raed
you wish
to
Raed
repeatedly
(One Program Repeat "m= ON" )
Program
(One Program Repeat "m= ON" )
m ON"
Norma! playback
Automatic rewind
a me an ae Go me ee
»
Automatic playback
(Forward playback)
Will be repeated
continuously until
Automatic rewind
cancelled.
a
are
*
Automatic playback
Automatic rewind
eee
od
*
Automatic playback
O
One Program Repeat "
OFF"
During reverse playback, the direction of tape travel will be the
opposite that shown above.
in the following cases, the one program repeat function may
not operate properly, but this is not the result of equipment
malfunction.
eWhen
batteries become depleted.
When the non-recorded interval between selections is less
than 4 seconds.
When a selection contains passages recorded at extreme-
ly low sound levels, or non-recorded
portions.
When the One Program Repeat Button is set to "am ON"
immediately prior to the end (within 5-6 seconds before
the end) of the selection you wish to play back repeatedly.
—13—
SLEEP
FUNCTION
The Power Switch can be used as a "'sleep timer" when set
to the '""N OFF/SLEEP"
position.
This ''sleep" position, which functions only when the tape is
running, is very convenient when you want to go to sleep
while recording or listening to a tape or radio broadcast.
The tape auto stop feature is employed to turn the power off
when a cassette tape of a desired length reaches the end.
@ How to listen to or record a radio broadcast
while sleeping
1) Press the Power Switch to '= ON".
2) Insert a cassette tape of the desired length.
(The sleep time is determined by the length of the tape.)
C-30
15 minutes
press
the
Notes:
eThe sleep function operates in one direction only;
during its use, auto-reverse will not operate.
Be suré to press the One Program Repeat Button to
"HOFF".