Panasonic SA-AK521 Betriebsanleitung - Seite 13

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Stereo System Panasonic SA-AK521 herunter. Panasonic SA-AK521 40 Seiten. Cd stereo system model no. sc-ak521

Seite drucken

Radio

Manual tuning

Press [TUNER, BAND] to select band.

The unit comes on.

Every time you press the button:

Press [PLAY MODE] on the remote control to select

"MANUAL".

Every time you press the button:

MANUAL

PRESET

Hold down [g/REW/3] or [f/FF/4] for a moment

to search for a station.

The frequency stops when it finds a clear station.

To stop during the process, press [g/REW/3] or [f/FF/4].

Under excessive interference, a station may not be found.

Press [g/REW/3] or [f/FF/4] repeatedly to tune step-by-

step.

"TUNED" is displayed when a radio station is tuned.

"ST" is displayed when a stereo FM broadcast is being

received.

If noise is excessive in FM

Remote control only

Hold down [PLAY MODE] to display "MONO"

Monaural sound is selected and noise reduces when reception is

weak.

Hold down [PLAY MODE] again to cancel the mode.

"MONO" is also cancelled if the frequency is changed.

Allocation setting

Main unit only

: By adjusting the allocation, you can enable this tuner to receive

FM broadcasts allocated in 0.1MHz steps.

GCP

: By adjusting the allocation, you can enable this tuner to receive

AM broadcasts allocated in 10 kHz steps.

Hold down [TUNER, BAND]. The display changes in a few seconds to

show the current minimum frequency. Continue to hold down the

button until the minimum frequency changes. The step is changed.

Repeat the above to change the step back.

Note

•

After changing the "allocation" setting, the frequencies you previously

preset in the memory will be cleared.

•

Sound is momentarily interrupted if you load/unload tapes while

listening to an AM broadcast.

Preset tuning

Remote control only

There are two methods of pre-setting stations.

Automatic presetting : All the stations the tuner can receive are

Manual presetting

Up to 15 stations each can be set in the FM and AM bands.

Preparation:

Press [TUNER, BAND] to select "FM" or "AM".

Automatic presetting

Do the following once each for FM and AM.

Preparation: Tune to the frequency where pre-setting is to begin.

Hold down [PROGRAM] until the frequency changes.

The tuner presets all the stations it can receive into the channels in

ascending order. When finished, the last station memorized is tuned in.

Manual presetting

Pre-set the stations one at a time.

1 Press [PROGRAM] then press [g, REW/3 ] or

[f, 4/FF] to tune to the desired station.

2 Press [PROGRAM] then press [g, REW/3 ] or

[f, 4/FF] to select a channel.

3 Press [PROGRAM].

The station occupying a channel is erased if another station is preset

in that channel.

Selecting channels

Press the numbered buttons to select the channel.

To enter channel 10 or over, press [X10], then the two digits.

1 Press [PLAY MODE] to select "PRESET".

2 Press [g, REW/3] or [f, 4/FF] to select the

channel.

preset.

: You can select the stations to preset and the

order they are preset in.

RQT7418