Panasonic SA-AK750 Betriebsanleitung - Seite 7

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Stereo System Panasonic SA-AK750 herunter. Panasonic SA-AK750 20 Seiten. Panasonic sc-ak750 stereo systems: operating instruction
Auch für Panasonic SA-AK750: Betriebsanleitung (28 seiten)

Seite drucken

Optional antenna connections

Use outdoor antenna if radio reception is poor.

Note:

Disconnect the outdoor antenna when the unit is not in use. Do not use the outdoor antenna during a lightning storm.

FM outdoor antenna

(

Rear panel

of this unit

• Disconnect the FM indoor antenna.

• The antenna should be installed by a competent

technician.

Preparing the remote control

AA/R6/LR6

DEMO function

7, STOP, –DEMO

RQTV0205-B.indd 7

AM outdoor antenna

Rear panel

of this unit

FM outdoor antenna

(not included)

75 Ω coaxial cable

(not included)

• Run a piece of vinyl wire horizontally across a window or

other convenient location.

• Leave the loop antenna connected.

■ Batteries

• Insert so the poles (+ and –) match those in the remote control.

• Remove if the remote control is not going to be used for a long period of

time. Store in a cool, dark place.

• Replace if the unit does not respond to the remote control even when held

close to the front panel.

• Do not use rechargeable type batteries.

• Mishandling of batteries in the remote control can cause electrolyte

leakage, which may cause a ﬁ re.

• If electrolyte leaks from the batteries, consult your dealer.

Wash thoroughly with water if electrolyte comes in contact with any part of

your body.

Do not:

• mix old and new batteries.

• use different types of batteries at the same time.

• heat or expose batteries to ﬂ ame.

• take apart or short circuit the batteries.

• attempt to recharge alkaline or manganese batteries.

• use batteries if the covering has been peeled off.

• put heavy objects on the remote control.

• spill liquids onto the remote control.

■ Use

Aim at the remote control sensor, avoiding obstacles, at a maximum range

of 7 m directly in front of the unit.

Refer to page 8 for the remote control sensor position.

When the unit is ﬁ rst plugged in, a demonstration of its functions may be

shown on the display.

If the demo setting is off, you can show a demonstration by selecting "DEMO

ON".

Press and hold [7, STOP, –DEMO].

The display changes each time the button is held down.

NO DEMO (off) Ô DEMO ON (on)

While in standby mode, select "NO DEMO" to reduce power consumption.

Note:

DEMO function cannot be turned on when Dimmer is on.

AM outdoor antenna

(not included)

5-12 m

AM loop antenna

(included)

2/22/07 7:02:07 PM

RQT8043