bioMetric SpinalPak Vollständiges Handbuch - Seite 6

Blättern Sie online oder laden Sie pdf Vollständiges Handbuch für Medizinische Ausrüstung bioMetric SpinalPak herunter. bioMetric SpinalPak 20 Seiten. Non-invasive spine fusion stimulator system

Seite drucken

System Components

BATTERY PACK AND BATTERY CHARGER
Biomet
SpinalPak
The
®
Upon receipt, it is recommended that the second battery pack be immediately placed into the charger cradle and fully
charged. In the meantime the first battery pack may be used to begin your treatment.
Note: The first battery pack may not provide a 24-hour treatment initially. It is recommended that the patient keep one
battery pack in the battery charger cradle to assure that it is fully charged and ready, and the other inserted into the
Biomet
SpinalPak
Non-invasive Spine Fusion Stimulator System. This will ensure continuous treatment prescribed by
®
®
the prescribing physician.
The battery charger and cradle are designed to recharge the
System battery packs only. Two LED (light emitting diode) lights monitor and indicate the operational status of the battery
charger. The A/C Power indicator light is located on the A/C Adaptor. The charging status indicator light is located on the
charger cradle. The following table lists and describes the operational functions of the LED lights:
Status
No battery pack inserted
(idle) on A/C powered
battery charger
Battery pack in charging state
Fully charged battery pack
A/C power deficiency
Error
Following are possible error conditions and possible resolutions.
Error Conditions (flashes orange)
Battery pack not properly connected
to the charger
Battery temperature is too low or high
Battery voltage is too low
Electrodes
There are two types of electrodes that are packaged with the Biomet
Fusion Stimulator System assembly: 72R and LT-4500. The 72R electrodes have green writing on their
packaging. The LT-4500 electrodes have black writing on their packaging. The 72R electrodes have a
hydrogel that is stickier than the LT-4500 electrode hydrogel. The patient can use whichever electrodes
best suit their skin type.
Electrode Covers
The electrode covers are water resistant and are intended to enhance electrode security to the skin, if
needed, or for showering with the electrodes attached, if desired.
Device Holster
The device holster is designed to securely hold the Biomet
Stimulator System in place. It has a clip on the back which allows the patient to wear the device on
their waistband or belt.
Lead Wires
Two different length lead wires are included with the Biomet
Stimulator System. The patient should choose the lead wire that best accommodates their needs for
where they would like to wear the control unit.
Non-invasive Spine Fusion Stimulator System includes two rechargeable battery packs.
®
Biomet
SpinalPak
®
A/C Power
Indicator Light
Solid green
Solid green
Solid green
Off
Solid green
Remove and re-install the battery pack to
ensure a complete connection to the charger
Normal operating temperature is
5°C to 38°C [41°F - 100°F]
Call Biomet for a new battery pack
SpinalPak
®
SpinalPak
®
4
Non-invasive Spine Fusion Stimulator
®
Charging Status Indicator
Light on Cradle
Off
Solid orange
Solid green
Off
Off
Possible Resolutions
SpinalPak
Non-invasive Spine
®
®
Non-invasive Spine Fusion
®
Non-invasive Spine Fusion
®