BION TECHNOLOGIES cambium xl Benutzerhandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Controller BION TECHNOLOGIES cambium xl herunter. BION TECHNOLOGIES cambium xl 11 Seiten.

Commissioning

RS232 Triggering

Make a cable using the 3 pins : TX, RX and G (GND) Set the RS232 parameters to : 9600bds 8 bits, no Parity, 2 Stop bits

To play a scene, send 3 bytes : 1 x y 255

To stop a scene, send 3 bytes : 2 x y 255

To pause a scene, send 3 bytes : 3 x y 255

To release a pause, send 3 bytes : 4 x y 255

To reset a scene, send 3 bytes : 5 x y 255

When (y)=0, (x) can be set between 0 and 255 -to stop scene 145, send the command: 2 145 0 255 When (y)=1, (x) can be set between

0 and 243 to trigger scenes 256-499 -to play scene 300, send the command: 1 255 45 255

TCP Triggering

The controller can be connected to an existing automation system over a network and triggered via TCP package on port 2431 or UDP

packets on 2430. Refer to the remote protocol document for more information.

Network Control

The controller can be connected to a local network, allowing it to be controlled from a smartphone or tablet over WiFi.

Connect the controller to a router or switch with an RJ45 cable

The controller is set by default to get an IP address from the router via DHCP. If the network is not working with DHCP, a manual

IP address and subnet mask can be set using the Hardware Manager

If the network has a filewall enabled, allow ports 2430 and 2431

6 | www.biontechnologies.com