EasyPro EXP8700-2 Series Installations- und Wartungshandbuch - Seite 2
Blättern Sie online oder laden Sie pdf Installations- und Wartungshandbuch für Water Pump EasyPro EXP8700-2 Series herunter. EasyPro EXP8700-2 Series 4 Seiten.
TWO SPEED PRIMER • EXP8700-2
We congratulate you on your choice of the EXP Self Priming Pump! It has been carefully designed using the advantages of today's
technology and carefully constructed to give you the dependability of yesterday. To insure proper performance, we urge you to carefully
follow the instructions in this manual. If you have any questions, call your nearest distributor or EasyPro for assistance.
INSTALLATION
Please read carefully! When properly installed this primer pump will provide dependable trouble-free service.
1. Locate pump as near the source to be pumped as possible. A flooded suction situation is preferred. This pump is self-priming, however, there must be
fluid in the pump for it to function properly. A check valve is recommended for non-flooded suction. (Figure 2)
2. Mount motor base to a secure, immobile foundation.
3. Use only plastic fittings on both the intake and discharge ports. Seal pipe connections with Teflon™ paste. These fittings should be self-supported
and in neutral alignment with each port. (i.e. Fittings must not be forced into alignment which may cause premature line failure or damage to the pump
volute.)
4. Never restrict the intake. Keep both input and discharge lines as free of elbows and valves as possible. Always use pipe of adequate diameter.
This will reduce friction losses and maximize output.
5. This pump must not be run dry! We recommend a flooded suction installation. Please read carefully! When properly installed, the pump will provide
dependable, trouble-free service.
6. Before starting pump, the priming pot must be filled with water.
(FIGURE 2)
WARNING: ALWAYS SHUT OFF ELECTRICAL POWER BEFORE INSTALLATION AND / OR SERVICING THIS PUMP!
ALL ELECTRICAL WIRING SHOULD MEET STATE AND LOCAL ORDINANCES. IMPROPER WIRING MAY NOT ONLY BE A
SAFETY HAZARD BUT MAY PERMANENTLY DAMAGE THE MOTOR AND/OR PUMP!
ELECTRICAL HOOK-UP
1. Check that supply voltages match the motor's requirements.
2. Check motor wiring and connect, according to instructions on motor, to match supply voltage.
3. Power cord should be protected by conduit or by cable and be of proper gauge. It should be no longer than necessary.
4. Power should be drawn directly from a box with circuit breaker protection or with a fused disconnect switch.
BALL VALVE
SUCTION LIFT
PRIMER
Reliability You Can Count On!
FLOODED SUCTION
WARNING: DO NOT RUN DRY!
SWING CHECK VALVE
© 2019 EasyPro, Inc
Pg. 2