EasyPro Stratus SRC Series Anweisungen

Blättern Sie online oder laden Sie pdf Anweisungen für Beleuchtungsanlagen EasyPro Stratus SRC Series herunter. EasyPro Stratus SRC Series 2 Seiten. Repair kit

Seite drucken
1. Piston Cups
2. Cylinders
3. Cyliner O-rings
4. Head O-rings
5. Cup Retainer Screws
*Repair kit contents may vary depending on your
compressor. The SRC50K contents are shown,
SRC25K will have half the components shown
for single cylinder repair.
WARNING: Electrical shock hazard. Disconnect electrical
supply before performing maintenance. Vent all air lines
to release vacuum or pressure. Failure to follow these
instructions may result in death, fire or electrical shock.
WARNING: Injury hazard. Product surfaces become very hot during
operation, allow surfaces to cool before handling.
WARNING: Do not use oil to lubricate parts. SRC compressors use
an oil less design. Using oil may result in failure of the unit.
1.
Remove screws from the head of compres-
sor using T25 Torx driver, remove the head
4.
Remove screws from cup retainer plate
with T15 Torx driver. Discard old cups and
retainer screws.
Stratus SRC Series Repair Kit Instructions
Repair Kit
2.
Mark the orientation of head plate(s) and re-
move. Mark the orientation of valve plate(s),
remove valve plate(s). Clean valve plates
with water based solvent, take care not to
scratch valve seats.
5.
Set new cylinder(s) on piston(s).
1.
2.
5.
4.
Before beginning, you will need:
1. T15 and T25 Torx driver
2. Torque driver
3. Utillity knife
4. Clean work space
3.
Remove old cylinders and discard.
6.
Remove new piston cup(s) from protective
cardboard packaging. Set new piston cups
onto retainer plate, these parts will sit flat
against each other.
3.