Dickert E19 Montage- und Betriebsanleitung - Seite 5

Blättern Sie online oder laden Sie pdf Montage- und Betriebsanleitung für Hausautomatisierung Dickert E19 herunter. Dickert E19 8 Seiten. Wireless receiver

Seite drucken

4 Intended use



The socket receiver is only approved for connection of the operating voltage listed under Technical Data,

see Point 11.



The wireless socket is switched between the mains socket and consumer.



The connecting in series of several connector housings (e.g. in a timer) is not allowed!



Only operate socket receivers on authorized grounded outlets.



Attention! The connected consumers are only disconnected 1-pin from mains.



Do not open the housing! When opening there is the risk of touching live parts. Therefore re-

pairs must only be done by a technician that is familiar with the applicable regulations!

4.1.

Fitter / installer



These instructions require knowledge from electrical technicians, who can evaluate the work required

from you, detect possible sources of danger and take the suitable safety measures.



This manual is designed for the fitter /installer of the control system, as well as the further processing

industry, however not to give to the operator.



This manual is to be kept with the technical documentation of the system.

4.2.

Legal Prerequisites

The receiver corresponds to the requirements according to:



ETSI EN 300220-2



ETSI EN 301489-3



VDE0620-1



EN 61058-1

5 Improper use

Any use other than the intended use shall be considered improper use for which the manufacturer is not

liable. The fitter, electrician or operating organisation bears the risk and the liability here.

6 Installation / Connection

6.1.

Installation location



The environmental conditions are to be taken from the Technical Data, see point 11.



Do not select a location for installation where there are electro-magnetic fields. That is, not directly next

to contactors, power transformers, fluorescent lights, etc or their connection wires.



The installation location must be selected so that if necessary the socket receiver can be quickly pulled

out of the socket.



Protect socket receivers from weather influences. Moisture, extreme temperatures, vibrations

and impact loads must absolutely be avoided.



Use is only allowed in closed rooms, use out of doors is not allowed!

6.2.

Connecting the socket receiver

1. Plug the socket receiver directly in the grounded outlet.

2. Plug the consumer that should be switched in the socket receiver.

3. Teach the hand-held transmitter in the socket receiver, see point 7.

The installation is now completed.

28506100_E19_EN_2012-08-07_EN.docx

V2.1.2

(2007-06)

V1.4.1

(2002-08)

(2010-02)

(2008-09) incl. Authorizations 2009-07 and 2011-10

Receiver E19

5 / 8