Dickinson 1000 Gebrauchsanweisung - Seite 5

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Gas-Heizung Dickinson 1000 herunter. Dickinson 1000 15 Seiten. Propane cozy cabin heater

Seite drucken
2.
If your deck is not a flat surface where you want to install the exhaust cap,
fabricate a round wooden ring approximately 1/2 to 3/4 inches thick with a 2"
hole drilled through the middle on which to mount the deck cap. Mill the
underside of the pad to match the contour or angle of your deck. The top side of
the pad will then be a level surface for the flange of the exhaust cap. A teak winch
pad is ideal, and available from local marine dealers.
3.
Using a suitable bedding compound, screw the deck cap (and wooden ring if used)
in place. Use the supplied gasket between the cap and the ring or deck.
4.
Determine the length of the pipe required by measuring the distance between the
top of the heater and up into the deck cap. The pipe may be bent up to a 45° angle
with a 5" radius or more to by-pass deck beams or other obstructions (an
electrician's conduit bender does a good job). You can easily make a mock-up
using residential copper pipe before you bend the real thing.
5.
The maximum recommended length of stack is 10' (3.05m). If there are bends in
the stack, remove 18" (46cm) from the maximum length for every bend.
6.
Cut the stack to proper length, remove the heater, place the stack up into the
exhaust cap. Ensure the stack is butted up against the top of the inside of the cap
to form a complete seal. Install interior finishing ring ensuring that the stack does
not contact the ring.
7.
Replace the heater and fasten it permanently, remembering to reinstall the
protective washers between the feet of the heater and the mounting surface.
8.
The New Deck Cap (Nov 2006) has an adjustable vent cap. This cap can be
threaded down to close off the stack when the heater is not in use or if the boat is
in heavy weather and you wish to close the exhaust. Ensure that the vent is
open before using the heater. Using the heater when the vent cap is closed
could result in serious injury.
Propane (LPG) Fuel System
1.
Buy your cylinder, gauge, master solenoid valve and hose from a reputable marine
dealer, or your local LPG service center.
a)
We specifically recommend that only a high quality regulator be used with
your Dickinson Marine Cozy Cabin Heater. It must be set at 11" water
column. (In Europe this is sometimes expressed as .0274bar and is close to
.5psi).
www.dickinsonmarine.com
Form#7.2-70 Issue#2
~