dicodes Dani Extreme V2+ Handbuch - Seite 10
Blättern Sie online oder laden Sie pdf Handbuch für Verdampfer dicodes Dani Extreme V2+ herunter. dicodes Dani Extreme V2+ 12 Seiten.
Auch für dicodes Dani Extreme V2+: Handbuch (12 seiten)
Seite drucken06 Extended Functions Menu
The display mode shows several parameters during the vape.
With display mode =1 in Temperature Controlled Mode, the parameters shown are
temperature, coil resistance, temperature regulating power and battery voltage.
For standard, boost and heater protection modes the parameters shown are the
selected power (static, no change), the coil resistance and the battery.
In "Bypass" mode the display will show coil resistance, battery voltage and calculated
power as there is no fixed power setting in this mode.
When display mode =0 is selected, the values of the mentioned parameters at the end
of the vape are displayed for about 4 seconds.
The Dani Extreme V2+ can be used in 5 different modes. 3 of those modes are only
available when Expert-Mode is set to 1. They are "Power Boost", "Heater Protection"
and "Bypass". Standard and Temperature Control modes can be accessed through the
main menu.
Here is an overview of all of the modes:
- Standard:
Vaping with a constant power setting. The selected power is applied to the
coil, unless the coil's resistance affords a different power setting.
- Temperature The power applied to the coil is calculated by a temperature controller
Control:
which keeps the coil's temperature constant. NOTE: Set the
temperature coefficient and perform a calibration at room temp.
- Power Boost: The coil is quickly heated up initially. Moreover, a repetitive boost can be
selected. NOTE: Do not to set the power limit to a value too high. It's best
to use a lower normal power setting.
- Heater Protection: The power to the coil is repeatedly interrupted to enable liquid
flow and limit the temperature.
- Bypass:
The mod behaves like a mechanical mod, i.e. the battery voltage is applied
directly to the coil. The maximum current is limited to 15A. Note that the
vape now depends on the power level of the battery combined with the
resistance of the coil. The resistance of the coil in use should not be very
low as the 15A limit would be easily reached.