Alpha Outback Energy AlphaNet DM3.0 Series Schnellstart-Handbuch - Seite 2
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Monitor Alpha Outback Energy AlphaNet DM3.0 Series herunter. Alpha Outback Energy AlphaNet DM3.0 Series 6 Seiten. Docsis status monitor
Seite drucken
5. If applicable, remove the old transponder from the inverter module.
6. Verify the Jumpers (J10 and J11) on the transponder are in the correct position for an XM3 installation (Fig. 1).
7. Set the notch at the back of the DM3.0 Series Transponder onto the white stand-off on the side of the Inverter
Module (Fig. 2). Then, line up the 18-pin connector on the transponder (Fig. 3) with the 18-pin socket on the
Inverter Module and connect the two units together
8. Fasten the transponder to the Inverter Module by tightening the two captive screws (Fig. 1). It is recommended
that the screws be tightened alternately, a few turns at a time, so the transponder aligns in parallel to the Inverter
Module.
Place the
jumper on the
XM3-labeled
position
Fig. 1, Captive Screw Locations and Jumpers
NOTICE:
When connecting the DM3.0 Series Transponder to the power supply, ensure that the notch at the back of the
DM3.0 Series Transponder is set on the stand-off on the side of the Inverter Module. Ensure that ALL 18 pins are
lined up to the proper sockets.
2
Captive
Screw
Mounting Notch
Captive
Screw
Fig. 2, Connecting the Transponder
Fig. 3, 18-pin Connector
Standoff
Piece
18 Pin
Connector
to the Inverter Module
18-pin
connector
704-939-B1-001, Rev. A (09/2020)