DieHard 200.71225 Benutzerhandbuch - Seite 10

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Batterieladegerät DieHard 200.71225 herunter. DieHard 200.71225 20 Seiten. Microprocessor controlled, fully automatic operation battery charger with engine starter plus battery and alternator tester for 6 and 12-volt batteries
Auch für DieHard 200.71225: Benutzerhandbuch (17 seiten)

Seite drucken

FEATURES

10.

ASSEMBLY INSTRUCTIONS

Included with your battery charger are two cord wrap cleats for storage of

the clamp cables.

10.1

To install, align the two tabs to correspond with the two receptacles and

push until you hear a snap.

11.

USINg THE ENgINE START FEATURE

Your battery charger can be used to jump start your car if the battery is

low. Follow these instructions on how to use the ENGINE START feature.

IMPORTANT: Follow all safety instructions and precautions when charg-

ing your battery. Wear complete eye protection and clothing protection.

Charge your battery in a well-ventilated area.

IMPORTANT: Using the ENGINE START feature WITHOUT a battery

installed in the vehicle could cause damage to the vehicle's electrical

system.

11.1

For battery connections, see CHARGING BATTERY IN THE VEHICLE

section. With the charger plugged in and connected to the battery of the

vehicle, set the CHARGE RATE to 80A START. Only the 80A START,

CHARGING, and VOLTAGE LEDs should be lit, unless the 6V REGULAR

battery type has been selected. In that case, the 6V REGULAR LED will

also be lit.

11.2

Crank the engine until it starts or 5 seconds passes. If engine does not

start, wait 3 minutes before cranking again.

11.3

After the engine starts, unplug the power cord before disconnecting the

output clamps from the battery.

Carrying Handle

Charger Status LEDs

Display Mode Select Switch

Battery Type Select Switch

Charge Rate Select Switch

Digital Display

Battery Clamps

•