DieHard 200.71233 Benutzerhandbuch - Seite 12
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Batterieladegerät DieHard 200.71233 herunter. DieHard 200.71233 15 Seiten. Battery charger 50/1512 amp manual; engine starter with battery tester and air compressor 225/125 amp
Auch für DieHard 200.71233: Benutzerhandbuch (15 seiten)
Seite drucken
Charging
your
battery
outside
the vehicle:
NOTE: A marine (boat) must be removed and charged
on shore. To charge it on board requires equipment
specially designed for marine use.
1.
Remove battery from vehicle, making sure to dis-
connect grounded terminal first with all power
turned off to the vehicle.
2.
Check the polarity of the battery posts as indicated
on the battery case: POSITIVE (POS,P,+) and
NEGATIVE
(NEG,N,-).
NOTE: On top-post batteries, the positive battery
terminal usually has a larger diameter than the
negative one.
3.
Connect the red (POSITIVE) charger clamp to the
POSITIVE post of the battery. Be sure to rock the
clamp back and forth to make a solid connection.
4.
Attach at least a 6-gauge (AWG) insulated battery
cable of at least 24-inches in length to the NEGA-
TIVE battery post. This cable will provide a safer
connection because any arcing and sparking will
not occur directly over the battery. (The battery
cable is not provided with the charger but may be
purchased at most automotive accessory outlets.)
Positive
(+)
5.
Take the other end of the 6-gauge
(AWG)
insu-
lated battery
cable (at least 24-inches
in length),
and, standing
as far away from the battery
as
possible,
connect
the black (NEGATIVE)
charger
clamp to the free end of the cable.
Be sure to rock
the clamp
back and forth to make a solid connec-
tion.
IMPORTANT:
Wear
safety glasses
and face
away from battery
while you are making the final
connection.
6.
Make
sure the power
is set to the OFF position.
Then, plug the power cord into a grounded
3-
prong AC wall outlet.
7.
Push the switch
located
on the front panel to
CHARGE.
8.
Press the TIMER
to the desired
charge
time, from
30-135
minutes.
If more than
135 minutes
of
charging
time is needed
the hold position
can be
used. When using the HOLD
feature the battery
being charged
must be monitored
closely
to avoid
over-charging.
9.
Press the VOLT/AMP
SELECTOR
to the desired
charge
position.
(See "CHARGE
RATE" chart on
page 12 for correct
settings.)
10. When the battery
is fully charged,
turn OFF the
timer, then push the switch located
on the front
panel to OFF. Unplug
the charger
power cord from
the wall outlet.
1f. Face away from battery
and remove
the charger
clamps
from the NEGATIVE
end of the cable first,
then from the POSITIVE
post.
12. Clean and store the battery
charger.
11