EPH Controls OpenTherm RFRP-HW-OT Betriebsanleitung - Seite 2
Blättern Sie online oder laden Sie pdf Betriebsanleitung für Empfänger EPH Controls OpenTherm RFRP-HW-OT herunter. EPH Controls OpenTherm RFRP-HW-OT 2 Seiten.
Seite drucken
RF1A-OT - Wireless Receiver
with RFRP-HW-OT
5. Resetting the RF1A-OT receiver
Press the
button located on the side of the receiver. The RF1A-OT
RESET
receiver is now reset.
6. To connect the RFRP-HW-OT thermostat to an RF1A-OT
receiver
Please note, If you are installing a CP4-HW-OT, the RFRP-HW-OT thermostat
and the RF1A-OT receiver will have a pre-established RF connection so it is
not necessary to carry out the RF connection process below.
On the RF1A-OT receiver:
Press the
button on the RF1A-OT receiver.
Connect
The red light will begin to ash.
On the RFRP-HW-OT thermostat:
Press the
button.
Connect
The thermostat will show "nOE" followed by "---"
Once an RF connection has been established the thermostat will show 'r01'
on the LCD screen.
Press the 'OK' button to nish the process.
The thermostat is now connected to the RF1A-OT receiver.
7. To disconnect the RFRP-HW-OT thermostat from an
RF1A-OT receiver
This can be done from either the thermostat or the receiver.
7.1 On the RFRP-HW-OT thermostat:
Press the
button.
Connect
The thermostat will begin to search through the RF channels.
Press and hold the 'Copy' button for 10 seconds.
'Adr' will appear on the screen of the thermostat.
Press the 'OK' button twice to complete the unpairing process.
The thermostat RFRP-HW-OT is now disconnected from the receiver
RF1A-OT.
7.2 On the RF1A-OT receiver:
Press the
button, the red light will ash.
Connect
Red & green lights if using as a hub receiver.
Press and hold connect for about 10 seconds, the receiver will then stop ashing.
The RF connection is now cleared.
EPH Controls Ireland
[email protected] www.ephcontrols.com
Page 2 of 2
Operating Instructions
EPH Controls UK
[email protected] www.ephcontrols.co.uk
20191011_RF1A-OT_RFRP-HW-OT_OpIns_JW