EPHESUS Arena 650 Installationsanleitung Handbuch - Seite 9

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für DJ-Ausrüstung EPHESUS Arena 650 herunter. EPHESUS Arena 650 16 Seiten. All field led luminaire

Seite drucken

1. Step 1 - Mount the Luminaires

Do not damage or cut the wire insulation (covering) during installation. Do not permit wires to contact any surface

having a sharp edge, as this may damage the wire insulation and create the risk of electrical shock. FAILURE TO

FOLLOW THIS WARNING MAY LEAD TO DEATH, SEVERE INJURY, OR PROPERTY DAMAGE.

Control Wiring

Always turn power to fixture OFF before performing any work on control wiring. Turn transmitters off before working

on main control lines. Performing any work on control connections while fixtures are receiving the signal may

result in transient or fluttering control signals which can cause damage to the luminaire. FAILURE TO FOLLOW THIS

WARNING MAY LEAD TO LUMINAIRE INTERNAL DAMAGE AND FAILURE.

Control Standards

All control work shall conform to ANSI E1.11 – 2008 (r2013), USITT DMX512-A, Asynchronous Serial Digital Data Transmission

Standard for Controlling Lighting Equipment and Accessories. At a minimum DMX cable shall be 1-pair (24AWG, 7x32

Stranding) Twisted (minimum of 4.8 twists/foot), Shielded, minimum of 100 ohms impedance, and <25pF/ft. Capacitance.

Use caution when connecting any 24AWG wires as they are more susceptible to breaking.

If using wireless controls, cap off each control wire in the luminaire junction box individually with splicing connector or

wire nut.

If using wired controls, route the incoming control line into the left side of the fixture junction box by removing the plug

and providing and installing a ½" (or metric equivalent) cord grip appropriately sized to hold the control wires securely.

Connect the incoming control wires to the fixture control wires. If connecting multiple fixtures in daisy-chain

configuration, connect the incoming wires to both the fixture wires and the outgoing wires.

Ensure all power and control wires are securely terminated and there are no exposed conductors. Carefully push power

and control wires down into their respective halves of the junction box to ensure no wires get pinched by the cover.

Reinstall fixture junction box cover and torque screws to 35-75 in-lbs (4-8 N-m).

Step 4 – Aim The Luminaires

Aiming the luminaires is a critical part of the LED lighting solution to ensure that light is evenly distributed on the playing

surface. There are two basic methods to properly aim a sports venue – Precision Laser Aiming by Coordinates, and

Orient-Tilt.

Precision Laser Aiming by Coordinates

Laser aiming is the most effective and preferred technique for aiming Ephesus LED sports lighting. This method uses a laser

mounted to the luminaire to point the fixture at a predetermined point on the playing surface using (X,Y) coordinates.

Unless otherwise noted, aiming coordinates on Ephesus photometrics or project Installation drawings are based on the

origin (0,0,0) placed at center field, court, or ice. All dimensions from that point are in feet along the playing surface unless

otherwise noted.

WARNING

Fixture control wire color

Purple

Grey

Yellow

Control Wiring Connections

Installation Instructions - All Field LED Luminaire

Designation

Data +

Data -

Shield

EATON

MN507001EN

All Field Installation Manual rev 20170324