DieHard Portable Power 750 Benutzerhandbuch - Seite 7
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Fernstart DieHard Portable Power 750 herunter. DieHard Portable Power 750 7 Seiten. 12v dc power source and jump starter
Auch für DieHard Portable Power 750: Benutzerhandbuch (8 seiten), Benutzerhandbuch (8 seiten)
Seite drucken
• Clean the clamps and the case each time
you are finished using it.
• Recharge the unit once a month when not
in use.
PROBLEM
The Portable Power won't
jump start my car.
The Portable Power won't
power my 12V device.
The battery in the Portable
Power won't hold a charge.
or for information about troubleshooting or replacement parts,
Male-to-male accessory cable ................................................................................ 94500109
MAINTENANCE AND CARE
TROUBLESHOOTING
Clamps are not making
a good connection to the
battery.
Connections are reversed.
The Portable Power's battery
is not charged.
The vehicle's battery is
defective.
The Portable Power is not
turned on.
The 12V device is not
turned on.
The Portable Power's battery
is not charged.
The 12V device draws more
than 15A or has a short
circuit.
The battery is bad (will not
accept a charge).
BEFORE RETURNING FOR REPAIRS
If the above solutions do not eliminate the problem,
call toll-free from anywhere in the U.S.A.
7:00 am to 5:00 pm CT, Monday through Friday
REPLACEMENT PARTS/ACCESSORIES
• Store clamps on their support posts, to
ensure they do not come into contact with
any metallic surface.
• Never completely discharge the internal
battery.
POSSIBLE CAUSE
1-800-732-7764
7
•
•
REASON/SOLUTION
Check for poor connection to
battery and frame. Make sure
connection points are clean.
Disconnect the Portable Power
and reverse the clamps.
Press the Battery Status
button on the front of the unit.
The LEDs will indicate the
status of charge.
Have the battery checked.
Turn the jump start ON/OFF
switch to the ON position.
Turn on the 12V device.
Check the battery charge
status by pressing the Battery
Status button.
Disconnect the 12V device.
The internal breaker will
automatically reset after a
minute or two. Try the 12V
device again.
Have the battery checked.