Olympus Stylus 105 Anleitung Handbuch - Seite 4

Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Digitalkamera Olympus Stylus 105 herunter. Olympus Stylus 105 12 Seiten. Olympus infinity zoom 105 qd camera-film: instruction manual
Auch für Olympus Stylus 105: Spezifikationen (2 seiten), Spezifikationen (2 seiten), Anleitung Handbuch (13 seiten), Gebrauchsanweisung (4 seiten)

Seite drucken
Olympus Stylus 105 Anleitung Handbuch

USING THE STRAP

6
Attach the strap as shown.

LOADING AND CHECKING THE BATTERY

Use one 3 V lithium battery (CR2).
1. While pressing the bottom of the
1
battery compartment cover
it as indicated to open
Make sure the lens barrier is closed
before opening the battery
compartment cover.
2. Insert the battery correctly
2
Close the battery compartment
2
cover
.
A new battery lasts for about 10 rolls
of film.
3. Slide the lens barrier as indicated
1
until it clicks. Check the battery
power as noted on the LCD panel.
3
lights (turns off
Battery is OK. You can shoot.
automatically).
blinks and other
Battery is low and will need
indicators are displayed
to replace within the next few
normally.
photos.
Battery is dead and must be
blinks and other
replaced with a new one
indicators go out.
immediately.

LOADING THE FILM

1
2
1
, lift
2
.
3
1
.
4
7
1. Slide the back cover release upward
to open the back cover.
Do not touch the inside of the
camera, especially the lens.
2. Insert the film cartridge until it
clicks into position.
ISO400 film is recommended. If you
are going to use non-DX-coded film,
use ISO100 film.
Incorrect
Correct
3. Position the end of the film leader
ahead of the line pointed to with the
arrow (A), and align the edge of the
perforated section (B) with (C).
Make sure that the film is
positioned correctly between the
positioning guides (D). Then close
the back cover until it clicks. Make
sure the back cover release has
returned to the lower position.
The film automatically advances to
the first frame.
4. Open the lens barrier until it clicks.
Make sure the exposure counter on
the LCD panel reads " ".
If "
" blinks, reload the film.