Olympus BX3-25ND6 Anleitung Handbuch - Seite 29

Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Mikroskop Olympus BX3-25ND6 herunter. Olympus BX3-25ND6 36 Seiten.

Seite drucken

Fig. 16

Fig. 17

Attaching the Mercury Burner and

Lamp Housing5

1. Loosen the socket clamping screw @ using the Allen screwdriver.

2. Hold the upper section of lamp housing and pull it upward to remove

the socket section.

To prevent malfunctions, do not hold the lamp housing by the

CAUTION

centering knobs 2.

3. Place the socket section upside down as shown in Fig. 17.

} The lamp housing is equipped with the holder for transportation in the

factory shipment condition, or with an old burner when the burner is

replaced. Remove the holder or old burner by loosening the two burner

holding screws 3

4. Attach the + (positive) pole of the mercury burner | to the fixed mount

on the upper side, then the − (negative) pole to the mount on the lower

side.

· Be sure to use the USH-103OL (mfd, by OLYMPUS) burner.

CAUTION

· Be careful and avoid leaving fingerprints or contaminants on

the mercury burner. Otherwise, there is a danger of explosion

due to distortion of glass caused by the stains. If the burner

is contaminated, clean it by wiping gently with gauze slightly

moistened with absolute alcohol.

5. Attach the socket section with burner to the original position and tighten

the clamping screw @.

· Align the external edges of the lamp housing with those on

the socket section, and push the lamp housing straight down-

CAUTION

ward.

· Attach the lamp housing on the lamp housing installation po-

sition of the microscope system so that the heat radiating fins

face upward. To prevent a fire hazard, reserve ample spaces

above, below and on the rear of the lamp housing.

· Do not light the mercury burner while it is not mounted on the

microscope because the UV rays in its light are harmful to your

eyes.

· The UV rays in the light of the mercury burner may damage the

specimen if this is sensitive to UV rays.

}

CAUTION

6. Connect the connector of the lamp house to the power unit U-RFL-T.

7. Connect the power cord to the power unit, and insert the power plug into

the outlet.

Burner Service Life

USH-103OL : 300 hours

This value assumes light cycles composed of 2 hours of

lighting and 30 minutes of extinction. Do not turn it on and

off at a shorter cycle than the above, for this will shorten

the service life of the burner.

After replacing the burner, reset the hour counter of

the power supply unit to "0.0."

(Figs. 16 & 17)