Olympus CX41 Anleitung Handbuch - Seite 25

Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Mikroskop Olympus CX41 herunter. Olympus CX41 32 Seiten. System microscope
Auch für Olympus CX41: Übersicht (7 seiten), Anleitung (32 seiten)

Seite drucken

7-2 Detailed Assembly Procedure

Fig. 25

Fig. 26

Mounting the Bulb (Replacement of Bulb)

1. Turn the microscope frame on its side and pull the lamp housing knob

@ on the underside of the base to open the lamp housing cover.

2. Holding the halogen bulb ² contained in the polyethylene bag to

avoid leaving fingerprints on the bulb, fully insert the contact pins into

the bulb socket ³ When properly seated, pull off the polyethylene bag.

6 V, 30 W halogen bulb: 6V30WHAL (Philips 5761)

Always use the designated bulb. Use of improper bulb may result

in fire.

Do not touch the bulb with bare hands. If fingerprints are

accidentally left on the bulb, wipe the bulb with a soft, lint-free

cloth moistened with alcohol. Using a contaminated bulb will

shorten the service life of the bulb.

3. With the lamp housing knob still pulled out, close the lamp housing

cover. Then push in the lamp housing knob to lock the cover.

#The lamp housing cover cannot be closed if the knob is pushed in

before you attempt to close the cover.

Caution for Bulb Replacement During Use or Right After Use

Whenever you replace the bulb during use or right after use, first

move the main switch to "

from the wall outlet, and allow the bulb and parts around the bulb

to cool before touching.

#If the bulb burns out during an observation and needs to be

replaced, remove eyepieces, specimen, filter and other objects

likely to fall off, before tilting the microscope frame to replace the

bulb.

Mounting the Condenser

1. Turn the coarse adjustment knob @ to raise the stage to its highest

position.

2. Turn the condenser height adjustment knob ² to lower the condenser

holder to the position where the clamping screw ³ can be turned.

3. Insert the condenser | all the way into the mounting hole ƒ and

clamp by tightening the clamping screw ³. Positioning the condenser

with the diaphragm lever ... at the front facilitates operation.

4. Turn the condenser height adjustment knob ² to raise the condenser

holder to its highest position.

(Fig. 25)

" (OFF), disconnect the power cord

(Fig. 26)

CX41