Olympus DP71 Anleitung Handbuch - Seite 4

Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Mikroskop Olympus DP71 herunter. Olympus DP71 32 Seiten. Microscope digital camera
Auch für Olympus DP71: Anleitung Handbuch (32 seiten)

IMPORTANT
The DP71 microscope digital camera is designed to be connected to a camera adapter mounted on an
Olympus UIS2/UIS series of optical microscope for use in recording of microscopic magnified images at
high speed (about 3 seconds) and highest resolution while maintaining high picture quality and high
color reproduction. The DP71 incorporates a variety of functions for supporting image recording under
optimum conditions.
When the DP71 microscope digital camera is used with a camera adapter or a microscope from other
manufacturer than Olympus, the optical performance may not be manifested fully.

SAFETY PRECAUTIONS

CAUTION
Never connect or disconnect the interface cable while the main switch of the computer is set to " " (ON).
Otherwise, malfunction may result.
1. Before connecting or disconnecting the interface cable, make sure that the main switch of the computer is set to "
(OFF).
When connecting the interface cable, tighten firmly the lock screws on it and ensure that the connector will not slip out
before setting the main switch to "
2. The cords and cables are vulnerable to bend or twist. Do not apply excessive force to them.
3. To prevent the microscope from toppling down, avoid using microscope attachments that may make the total height of
the microscope above 1 meter when they are attached.
4. When installing the PCI interface board, be sure to hold it by the edge. Never touch the board surface directly, as this will
lead to malfunction.
The PCI interface board area shown in the illustration on
the right becomes very hot during and immediately after
use of the camera. Be careful never to touch them during
and after use.
5. Connect the provided power cord correctly and ensure that the
grounding terminal of the power supply and wall outlet are
properly connected. If the equipment is not grounded/earthed,
Olympus can no longer warrant the electrical safety performance
of the equipment.
6. Lay out the interface cable so that it does not contact the heat
generating section such as the lamp housing of the microscope.
1
" (ON).
Hot part
"